EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A Comparative Study of Molecularly Imprinted Polypyrrole Architectures for Electrochemical Quartz Microbalance-Based Method Development for Geraniol Adsorption

Greta Kaspute iD, Deivis Plausinaitis iD, Vilma Ratautaite iD, Evelina Vaicekauskaite iD, Arunas Ramanavicius iD, Urte Prentice iD

Polymers · 26.03.2026 · 18 (7) · 804

DOI: 10.3390/polym18070804 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 26.03.2026. Verfasst von Greta Kaspute und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Nanotechnology, State Research Institute Center for Physical Sciences and Technology (FTMC), Sauletekio Ave. 3, LT-10257 Vilnius, Lithu…. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Lithuanian Research Council Project.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Molecularly imprinted polymers (MIPs) are widely employed for selective adsorption of target molecules in sensing and separation applications. The architecture of MIP films can influence adsorption behavior, interfacial stability, and reusability, yet systematic investigations of these effects are limited. This study aimed to evaluate how different polypyrrole (PPy) MIP film architectures affect the adsorption, stability, and regeneration characteristics of geraniol-imprinted layers on gold electrodes. Geraniol-imprinted and non-imprinted PPy films were electropolymerized onto quartz crystal microbalance (QCM) substrates. Two film architectures were compared: (i) a single-layer geraniol-imprinted PPy film, and (ii) a double-layer film consisting of a non-imprinted PPy underlayer followed by a geraniol-imprinted layer. Film characterization was performed using cyclic voltammetry (CV) and electrochemical quartz crystal microbalance (EQCM) measurements. Adsorption–desorption cycles were conducted to assess mass uptake, signal stability, and regeneration performance. EQCM analysis revealed that the double-layer architecture exhibited enhanced frequency signal stability during repeated adsorption–desorption cycles compared to single-layer films, suggesting a stabilizing effect of the underlying non-imprinted PPy layer at the electrode interface. Geraniol-imprinted films demonstrated significantly higher mass uptake than non-imprinted controls, confirming the sensitivity provided by molecular imprinting. Single-layer films showed more variability in signal response and less consistent regeneration performance. The architecture of MIP films significantly affects adsorption behavior, stability, and regeneration on electrode surfaces. Incorporating a non-imprinted PPy underlayer can improve signal reproducibility and enhance the robustness of MIP-based sensing interfaces. These findings provide guidance for the rational design of MIP coatings for electrochemical sensors and QCM-active platforms.

Schlagwörter

Stichwörter der Autor:innen

analytical chemistryconducting polymerselectrochemical depositionelectrochemistrygeraniolmolecularly imprinted polymers (MIPs)sensors

Autor:innen und Institutionen

  • Department of Nanotechnology, State Research Institute Center for Physical Sciences and Technology (FTMC), Sauletekio Ave. 3, LT-10257 Vilnius, Lithuania.
  • Department of Physical Chemistry, Institute of Chemistry, Faculty of Chemistry and Geosciences, Vilnius University (VU), Naugarduko Str. 24, LT-03225 Vilnius, Lithuania.

ORCID-Profile: Greta Kaspute, Deivis Plausinaitis, Vilma Ratautaite, Evelina Vaicekauskaite, Arunas Ramanavicius, Urte Prentice

Förderung

  • Lithuanian Research Council Project

Zitieren

APA

Kaspute, G., Plausinaitis, D., Ratautaite, V., Vaicekauskaite, E., Ramanavicius, A., & Prentice, U. (2026). A Comparative Study of Molecularly Imprinted Polypyrrole Architectures for Electrochemical Quartz Microbalance-Based Method Development for Geraniol Adsorption. Polymers, 18(7), 804. https://doi.org/10.3390/polym18070804

Vancouver

Kaspute G, Plausinaitis D, Ratautaite V, Vaicekauskaite E, Ramanavicius A, Prentice U. A Comparative Study of Molecularly Imprinted Polypyrrole Architectures for Electrochemical Quartz Microbalance-Based Method Development for Geraniol Adsorption. Polymers. 2026;18(7):804. doi:10.3390/polym18070804

BibTeX
@article{Kaspute2026,
  author = {Kaspute, Greta and Plausinaitis, Deivis and Ratautaite, Vilma and Vaicekauskaite, Evelina and Ramanavicius, Arunas and Prentice, Urte},
  title = {A Comparative Study of Molecularly Imprinted Polypyrrole Architectures for Electrochemical Quartz Microbalance-Based Method Development for Geraniol Adsorption},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {7},
  pages = {804},
  doi = {10.3390/polym18070804}
}
Kostenlos starten →