EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Gamma-Ray Attenuation Performance of PEEK Reinforced with Natural Pumice and Palygorskite

Ahmed Alharbi iD

Polymers · 11.01.2026 · 18 (2) · 198

DOI: 10.3390/polym18020198 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 11.01.2026. Verfasst von Ahmed Alharbi. Beteiligte Einrichtung: Department of Physics, College of Science, Qassim University, Buraydah 51452, Qassim, Saudi Arabia. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deanship of Graduate Studies and Scientific Research at Qassim University.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Lightweight, lead-free polymer–mineral composites have attracted increasing interest as radiation-attenuating materials for applications where reduced mass and environmental compatibility are required. In this work, the γ-ray attenuation behavior of poly(ether ether ketone) (PEEK) reinforced with natural palygorskite and pumice was evaluated at filler concentrations of 10–40 wt%. Photon interaction parameters, including the linear attenuation coefficient (μ), half-value layer (HVL), mean free path (λ), and effective atomic number (Zeff), were computed over the energy range 15 keV–15 MeV using the Phy-X/PSD platform and validated through full Geant4 Monte Carlo transmission simulations. At 15 keV, μ increased from 1.46cm−1 for pure PEEK to 4.21cm−1 and 8.499cm−1 for the 40 wt% palygorskite- and pumice-filled composites, respectively, reducing the HVL from 0.69 cm to 0.24 cm and 0.11 cm. The corresponding Zeff values increased from 6.5 (pure PEEK) to 9.4 (40 wt% palygorskite) and 15.3 (40 wt% pumice), reflecting the influence of higher-Z oxide constituents in pumice. At higher photon energies, the attenuation curves converged as Compton scattering became dominant, although pumice-filled PEEK retained marginally higher μ and shorter λ up to the MeV region. These findings demonstrate that natural mineral fillers can enhance the photon attenuation behavior of PEEK while retaining the known thermal stability and mechanical performance of the polymer matrix as reported in the literature, indicating their potential use as lightweight, secondary radiation-attenuating components in medical, industrial, and aerospace applications.

Schlagwörter

Stichwörter der Autor:innen

PEEK compositespalygorskitephoton attenuationpumiceradiation shieldingsustainable materials

Autor:innen und Institutionen

  • Department of Physics, College of Science, Qassim University, Buraydah 51452, Qassim, Saudi Arabia.

ORCID-Profile: Ahmed Alharbi

Förderung

  • Deanship of Graduate Studies and Scientific Research at Qassim University

Zitieren

APA

Alharbi, A. (2026). Gamma-Ray Attenuation Performance of PEEK Reinforced with Natural Pumice and Palygorskite. Polymers, 18(2), 198. https://doi.org/10.3390/polym18020198

Vancouver

Alharbi A. Gamma-Ray Attenuation Performance of PEEK Reinforced with Natural Pumice and Palygorskite. Polymers. 2026;18(2):198. doi:10.3390/polym18020198

BibTeX
@article{Alharbi2026,
  author = {Alharbi, Ahmed},
  title = {Gamma-Ray Attenuation Performance of PEEK Reinforced with Natural Pumice and Palygorskite},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {2},
  pages = {198},
  doi = {10.3390/polym18020198}
}
Kostenlos starten →