EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Polyethylene and Polypropylene Pyrolysis Using Fe3+-Modified Kaolin Catalyst for Enhanced Gas and Pyrolysis Oil Production

Sergey Nechipurenko iD, Binara Dossumova, Sergey Efremov iD, Nazar Zabara, Aigerim Kaiaidarova iD, Olga Ibragimova, Anara Omarova, Fedor Pogorov iD, Diyar Tokmurzin

Polymers · 06.11.2025 · 17 (21) · 2963

DOI: 10.3390/polym17212963 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 06.11.2025. Verfasst von Sergey Nechipurenko und 8 weiteren Autor:innen. Beteiligte Einrichtung: Center of Physical Chemical Methods of Research and Analysis, Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, Alm…. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Calcined and acid-leached kaolin impregnated with Fe(NO3)3·9H2O (6.6 wt. % Fe2O3) was developed as an inexpensive bifunctional catalyst for the slow fixed-bed pyrolysis of polypropylene (PP) and low-density polyethylene (LDPE). Experiments were run with catalyst-to-plastic mass ratios of 1:4, 1:2, and 1:1 in a quartz tube reactor heated from 25 to 800 °C. For PP, increasing the Fe/kaolin loading progressively raised non-condensable gas from 26 wt. % to 44 wt. % and drove liquid aromatics from 27.9% to 72.3%, while combined paraffins olefins fell to 2.5% and wax exhibited a 46 → 24 → 36 wt. % trend. In contrast, LDPE at a 1:4 ratio already yielded 56 wt. % oil and only 22 wt. % wax; further catalyst addition mainly enhanced CH4/CO-rich pyrolysis gas (PyGas) and char without substantially boosting aromatics. Gas analysis confirmed that Fe2O3 reduction and kaolin de-hydroxylation generated in situ H2O, CO, and H2. Given the catalyst’s low cost, regenerability, and ability to valorize the two most abundant waste polyolefins within the same reactor, the process offers a scalable route to flexible fuel and gas production from mixed plastic streams.

Schlagwörter

Stichwörter der Autor:innen

catalytic pyrolysiskaolinpolyethylenepolypropyleneslow pyrolysisthermogravimetric analysiswaste plastics

Autor:innen und Institutionen

  • Center of Physical Chemical Methods of Research and Analysis, Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, Almaty 050012, Kazakhstan.
  • Laboratory for Chemical Technology, Ghent University, Industriele Scheikunde, Technologiepark-Zwijnaarde 125, 9052 Gent, Belgium.

ORCID-Profile: Sergey Nechipurenko, Sergey Efremov, Aigerim Kaiaidarova, Fedor Pogorov

Förderung

  • Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan

Zitieren

APA

Nechipurenko, S., Dossumova, B., Efremov, S., Zabara, N., Kaiaidarova, A., Ibragimova, O., Omarova, A., Pogorov, F., & Tokmurzin, D. (2025). Polyethylene and Polypropylene Pyrolysis Using Fe3+-Modified Kaolin Catalyst for Enhanced Gas and Pyrolysis Oil Production. Polymers, 17(21), 2963. https://doi.org/10.3390/polym17212963

Vancouver

Nechipurenko S, Dossumova B, Efremov S, Zabara N, Kaiaidarova A, Ibragimova O, et al. Polyethylene and Polypropylene Pyrolysis Using Fe3+-Modified Kaolin Catalyst for Enhanced Gas and Pyrolysis Oil Production. Polymers. 2025;17(21):2963. doi:10.3390/polym17212963

BibTeX
@article{Nechipurenko2025,
  author = {Nechipurenko, Sergey and Dossumova, Binara and Efremov, Sergey and Zabara, Nazar and Kaiaidarova, Aigerim and Ibragimova, Olga and Omarova, Anara and Pogorov, Fedor and Tokmurzin, Diyar},
  title = {Polyethylene and Polypropylene Pyrolysis Using Fe3+-Modified Kaolin Catalyst for Enhanced Gas and Pyrolysis Oil Production},
  journal = {Polymers},
  year = {2025},
  volume = {17},
  number = {21},
  pages = {2963},
  doi = {10.3390/polym17212963}
}
Kostenlos starten →