EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Preparation and Characterization of Graphene Oxide/Carbon Nanotube/Polyaniline Composite and Conductive and Anticorrosive Properties of Its Waterborne Epoxy Composite Coatings

Yufeng Li, Shibo Liu, Feng Feng, Yiming Li, Yahui Han, Xinyang Tong, Xiaohui Gao

Polymers · 19.09.2024 · 16 (18) · 2641

DOI: 10.3390/polym16182641 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 19.09.2024. Verfasst von Yufeng Li und 6 weiteren Autor:innen. Beteiligte Einrichtung: College of Chemistry and Chemical Engineering, Qiqihar University, Qiqihar 161006, China. Die Arbeit wurde bisher 30-mal zitiert (Crossref) und nennt 66 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Fundamental Research Funds in Heilongjiang Provincial Universities.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The organic coating on the surface is common and the most effective method to prevent metal materials from corrosion. However, the corrosive medium can penetrate the metal surface via micropores, and electrons cannot transfer in the pure resin coatings. In this paper, a new type of anticorrosive and electrically conductive composite coating filled with graphene oxide/carbon nanotube/polyaniline (GO/CNT/PANI) nanocomposites was successfully prepared by in situ polymerization of aniline (AN) on the surface of GO and CNT and using waterborne epoxy resin (WEP) as film-forming material. The structure and morphology of the composite were characterized using a series of characterization methods. The composite coatings were comparatively examined through resistivity, potentiodynamic polarization curves, electrochemical impedance spectroscopy (EIS), and salt spray tests. The results show that the GO/CNT/PANI/WEP composite coating exhibits excellent corrosion resistance for metal substrates and good conductivity when the mass fraction of GO/CNT/PANI is 3.5%. It exhibits a lower corrosion current density of 4.53 × 10−8 A·cm−2 and a higher electrochemical impedance of 3.84 × 106 Ω·cm2, while only slight corrosion occurred after 480 h in the salt spray test. The resistivity of composite coating is as low as 2.3 × 104 Ω·cm. The composite coating possesses anticorrosive and electrically conductive properties based on the synergistic effect of nanofillers and expands the application scope in grounding grids and oil storage tank protection fields.

Schlagwörter

Stichwörter der Autor:innen

anticorrosive propertiescarbon nanotube (CNT)electrical conductivegraphene oxide (GO)polyaniline (PANI)waterborne epoxy (WEP)

Autor:innen und Institutionen

  • College of Chemistry and Chemical Engineering, Qiqihar University, Qiqihar 161006, China.
  • College of Light Industry and Textile, Qiqihar University, Qiqihar 161006, China.

Förderung

  • the Fundamental Research Funds in Heilongjiang Provincial Universities

Zitieren

APA

Li, Y., Liu, S., Feng, F., Li, Y., Han, Y., Tong, X., & Gao, X. (2024). Preparation and Characterization of Graphene Oxide/Carbon Nanotube/Polyaniline Composite and Conductive and Anticorrosive Properties of Its Waterborne Epoxy Composite Coatings. Polymers, 16(18), 2641. https://doi.org/10.3390/polym16182641

Vancouver

Li Y, Liu S, Feng F, Li Y, Han Y, Tong X, et al. Preparation and Characterization of Graphene Oxide/Carbon Nanotube/Polyaniline Composite and Conductive and Anticorrosive Properties of Its Waterborne Epoxy Composite Coatings. Polymers. 2024;16(18):2641. doi:10.3390/polym16182641

BibTeX
@article{Li2024,
  author = {Li, Yufeng and Liu, Shibo and Feng, Feng and Li, Yiming and Han, Yahui and Tong, Xinyang and Gao, Xiaohui},
  title = {Preparation and Characterization of Graphene Oxide/Carbon Nanotube/Polyaniline Composite and Conductive and Anticorrosive Properties of Its Waterborne Epoxy Composite Coatings},
  journal = {Polymers},
  year = {2024},
  volume = {16},
  number = {18},
  pages = {2641},
  doi = {10.3390/polym16182641}
}
Kostenlos starten →