Flexible Resistive Gas Sensor Based on Molybdenum Disulfide-Modified Polypyrrole for Trace NO2 Detection
Polymers · 07.07.2024 · 16 (13) · 1940
DOI: 10.3390/polym16131940 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 07.07.2024. Verfasst von Kuo Zhao und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Measurement and Control Technology and Communication Engineering, Harbin University of Science and Technology, Harbin 150080, China. Die Arbeit wurde bisher 22-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: ational Natural Science Foundation of China, China National Basic Enhancement Program, National Natural Science Foundation of China.
Abstract (Originalsprache)
High sensitivity and selectivity and short response and recovery times are important for practical conductive polymer gas sensors. However, poor stability, poor selectivity, and long response times significantly limit the applicability of single-phase conducting polymers, such as polypyrrole (PPy). In this study, PPy/MoS2 composite films were prepared via chemical polymerization and mechanical blending, and flexible thin-film resistive NO2 sensors consisting of copper heating, fluorene polyester insulating, and PPy/MoS2 sensing layers with a silver fork finger electrode were fabricated on a flexible polyimide substrate using a flexible electronic printer. The PPy/MoS2 composite films were characterized using X-ray diffraction, Fourier-transform infrared spectroscopy, and field-emission scanning electron microscopy. A home-built gas sensing test platform was built to determine the resistance changes in the composite thin-film sensor with temperature and gas concentration. The PPy/MoS2 sensor exhibited better sensitivity, selectivity, and stability than a pure PPy sensor. Its response to 50 ppm NO2 was 38% at 150 °C, i.e., 26% higher than that of the pure PPy sensor, and its selectivity and stability were also higher. The greater sensitivity was attributed to p–n heterojunction formation after MoS2 doping and more gas adsorption sites. Thus, PPy/MoS2 composite film sensors have good application prospects.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Measurement and Control Technology and Communication Engineering, Harbin University of Science and Technology, Harbin 150080, China.
- China Higher Educational Key Laboratory for Measuring & Control Technology and Instrumentations of Heilongjiang Province, Harbin 150080, China.
- The 49th Research Institute of China Electronics Technology Group, Harbin 150001, China.
Förderung
- ational Natural Science Foundation of China
- China National Basic Enhancement Program
- National Natural Science Foundation of China
Zitieren
APA
Zhao, K., Shi, Y., Cui, M., Tang, B., Zheng, C., Chen, Q., & Hu, Y. (2024). Flexible Resistive Gas Sensor Based on Molybdenum Disulfide-Modified Polypyrrole for Trace NO2 Detection. Polymers, 16(13), 1940. https://doi.org/10.3390/polym16131940
Vancouver
Zhao K, Shi Y, Cui M, Tang B, Zheng C, Chen Q, et al. Flexible Resistive Gas Sensor Based on Molybdenum Disulfide-Modified Polypyrrole for Trace NO2 Detection. Polymers. 2024;16(13):1940. doi:10.3390/polym16131940
BibTeX
@article{Zhao2024,
author = {Zhao, Kuo and Shi, Yunbo and Cui, Mingrui and Tang, Bolun and Zheng, Canda and Chen, Qinglong and Hu, Yuhan},
title = {Flexible Resistive Gas Sensor Based on Molybdenum Disulfide-Modified Polypyrrole for Trace NO2 Detection},
journal = {Polymers},
year = {2024},
volume = {16},
number = {13},
pages = {1940},
doi = {10.3390/polym16131940}
}
EUVIMED