EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Polyvinylalcohol Composite Filled with Carbon Dots Produced by Laser Ablation in Liquids

Mariapompea Cutroneo iD, Letteria Silipigni iD, Petr Malinsky, Petr Slepicka, Domenico Franco iD, Lorenzo Torrisi

Polymers · 13.05.2024 · 16 (10) · 1390

DOI: 10.3390/polym16101390 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 13.05.2024. Verfasst von Mariapompea Cutroneo und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Physics (MIFT), Messina University, V. le Ferdinando Stagno d'Alcontres 31, S. Agata, 98166 Messina, Italy. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: GACR, CANAM (Centre of Accelerators and Nuclear Analytical Methods), OP RDE, MEYS, Czech Republic.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Carbon dots (CDs), owing to their excellent photoluminescent features, have been extensively studied for physics preparation methods and for biomedical and optoelectronic device applications. The assessment of the applicability of CDs in the production of luminescent polymeric composites used in LEDs, displays, sensors, and wearable devices is being pursued. The present study reports on an original, environmentally friendly, and low-cost route for the production of carbon dots with an average size of 4 nm by laser ablation in liquid. Jointly, to prove the significance of the study for a wide range of applications, a free-standing flexible polyvinyl alcohol (PVA) composite containing photoluminescent carbon dots was manufactured. CDs were prepared using targets of porose charcoal with a density of 0.271 g/cm3 placed in phosphate-buffered saline (PBS) liquid solution and irradiated for 30 min by pulsed IR diode laser. The optical properties of the obtained suspension containing carbon dots were studied with UV-ViS and FTIR spectroscopies. The photoluminescence of the produced carbon dots was confirmed by the emission peak at 480 nm in the luminescence spectrum. A narrow luminescence band with a full width at half-maximum (FWHM) of less than 40 nm could be an asset in spectral emission analysis in different applications. Atomic force microscopy confirms the feasibility of manufacturing CDs in clean and biocompatible environments, paving the way for an easier and faster production route, crucial for their wider applicability.

Schlagwörter

Stichwörter der Autor:innen

PVAcarbon dotslaser ablation in liquidphotoluminescence

Autor:innen und Institutionen

  • Department of Physics (MIFT), Messina University, V. le Ferdinando Stagno d'Alcontres 31, S. Agata, 98166 Messina, Italy.
  • Nuclear Physics Institute, AS CR, 25068 Rez, Czech Republic.
  • Department of Physics, Faculty of Science, University of J. E. Purkyně, České mládeže 8, 40096 Ústí nad Labem, Czech Republic.
  • Department of Solid State Engineering, Institute of Chemical Technology, 16628 Prague, Czech Republic.
  • Department of Chemical, Biological, Pharmaceutical Sciences (ChiBioFarAm), University of Messina, V. le Ferdinando Stagno d'Alcontres 31, S. Agata, 98166 Messina, Italy.

ORCID-Profile: Mariapompea Cutroneo, Letteria Silipigni, Domenico Franco

Förderung

  • GACR
  • CANAM (Centre of Accelerators and Nuclear Analytical Methods)
  • OP RDE, MEYS, Czech Republic
  • Nuclear Institute of the Czech Academy of Sciences
  • Czech Science Foundation GACR

Zitieren

APA

Cutroneo, M., Silipigni, L., Malinsky, P., Slepicka, P., Franco, D., & Torrisi, L. (2024). Polyvinylalcohol Composite Filled with Carbon Dots Produced by Laser Ablation in Liquids. Polymers, 16(10), 1390. https://doi.org/10.3390/polym16101390

Vancouver

Cutroneo M, Silipigni L, Malinsky P, Slepicka P, Franco D, Torrisi L. Polyvinylalcohol Composite Filled with Carbon Dots Produced by Laser Ablation in Liquids. Polymers. 2024;16(10):1390. doi:10.3390/polym16101390

BibTeX
@article{Cutroneo2024,
  author = {Cutroneo, Mariapompea and Silipigni, Letteria and Malinsky, Petr and Slepicka, Petr and Franco, Domenico and Torrisi, Lorenzo},
  title = {Polyvinylalcohol Composite Filled with Carbon Dots Produced by Laser Ablation in Liquids},
  journal = {Polymers},
  year = {2024},
  volume = {16},
  number = {10},
  pages = {1390},
  doi = {10.3390/polym16101390}
}
Kostenlos starten →