EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Superabsorbent Polymer (SAP) Size on Microstructure and Compressive Strength of Concrete

Xiaobo Niu iD, Yile Zhang, Yogarajah Elakneswaran iD, Miyu Sasaki, Takeshi Takayama, Hajime Kawai

Polymers · 09.01.2024 · 16 (2) · 197

DOI: 10.3390/polym16020197 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 09.01.2024. Verfasst von Xiaobo Niu und 5 weiteren Autor:innen. Beteiligte Einrichtung: Division of Sustainable Resources Engineering, Faculty of Engineering, Hokkaido University, Sapporo 060-8628, Japan. Die Arbeit wurde bisher 24-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Superabsorbent polymers (SAPs) are hydrophilic, polymeric network materials renowned for their ability to enhance various properties of cementitious materials. This investigation examines the impact of SAP size on the hydration degree, porosity, and compressive strength of cement pastes and concrete under diverse curing conditions and ageing periods. The findings reveal that SAP addition stimulates the hydration of the C2S phase, particularly during the early curing stages, thereby favouring early strength development. However, the effect of SAPs on hydration promotion diminishes as their size increases. Conversely, the size of SAPs affects the hydration range of their action, and the 400 µm SAP demonstrates the most extensive range of hydration enhancement, reaching up to 105 µm. Additionally, SAPs effectively reduce porosity in small pores (4 nm–10 μm), with 200 μm and 400 μm SAPs exhibiting the highest efficacy. While analysing the effects of SAPs on larger pores (>10 μm), the results show that although larger SAPs result in larger average porosity, the total porosity is effectively reduced, particularly in samples incorporating 400 μm SAP. The compressive strength of cement paste, even after 28 days, is slightly reduced following the introduction of SAPs. However, the strength of concrete, due to the naturally occurring pores eliminating the negative effects of the pores produced by SAPs, is significantly increased following the introduction of SAPs, especially 400 µm SAP.

Schlagwörter

Stichwörter der Autor:innen

compressive strengthconcretehydration rateporositysizesuperabsorbent polymer

Autor:innen und Institutionen

  • Division of Sustainable Resources Engineering, Faculty of Engineering, Hokkaido University, Sapporo 060-8628, Japan.
  • Industrial & Household Chemicals Research Department, Industrial & Household Solutions Division, Nippon Shokubai, Osaka 564-0034, Japan.

ORCID-Profile: Xiaobo Niu, Yogarajah Elakneswaran

Zitieren

APA

Niu, X., Zhang, Y., Elakneswaran, Y., Sasaki, M., Takayama, T., & Kawai, H. (2024). Effect of Superabsorbent Polymer (SAP) Size on Microstructure and Compressive Strength of Concrete. Polymers, 16(2), 197. https://doi.org/10.3390/polym16020197

Vancouver

Niu X, Zhang Y, Elakneswaran Y, Sasaki M, Takayama T, Kawai H. Effect of Superabsorbent Polymer (SAP) Size on Microstructure and Compressive Strength of Concrete. Polymers. 2024;16(2):197. doi:10.3390/polym16020197

BibTeX
@article{Niu2024,
  author = {Niu, Xiaobo and Zhang, Yile and Elakneswaran, Yogarajah and Sasaki, Miyu and Takayama, Takeshi and Kawai, Hajime},
  title = {Effect of Superabsorbent Polymer (SAP) Size on Microstructure and Compressive Strength of Concrete},
  journal = {Polymers},
  year = {2024},
  volume = {16},
  number = {2},
  pages = {197},
  doi = {10.3390/polym16020197}
}
Kostenlos starten →