EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Synthesis and Characterization of a Novel Nanosized Polyaniline

Mohd Faizar Banjar iD, Fatin Najwa Joynal Abedin iD, Ahmad Noor Syimir Fizal, Norazilawati Muhamad Sarih, Md Sohrab Hossain iD, Hakimah Osman, Nor Afifah Khalil iD, Ahmad Naim Ahmad Yahaya iD, Muzafar Zulkifli iD

Polymers · 29.11.2023 · 15 (23) · 4565

DOI: 10.3390/polym15234565 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 29.11.2023. Verfasst von Mohd Faizar Banjar und 8 weiteren Autor:innen. Beteiligte Einrichtung: Malaysian Institute of Chemical and Bioengineering Technology, Universiti Kuala Lumpur (UniKL), Alor Gajah 78000, Melaka, Malaysia. Die Arbeit wurde bisher 34-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Higher Education.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Polyaniline (PANI) is a conductive polymer easily converted into a conducting state. However, its limited mechanical properties have generated interest in fabricating PANI composites with other polymeric materials. In this study, a PANI–prevulcanized latex composite film was synthesized and fabricated in two phases following chronological steps. The first phase determined the following optimum parameters for synthesizing nanosized PANI, which were as follows: an initial molar ratio of 1, a stirring speed of 600 rpm, a synthesis temperature of 25 °C, purification via filtration, and washing using dopant acid, acetone, and distilled water. The use of a nonionic surfactant, Triton X-100, at 0.1% concentration favored PANI formation in a smaller particle size of approximately 600 nm and good dispersibility over seven days of observation compared to the use of anionic sodium dodecyl sulfate. Ultraviolet–visible spectroscopy (UV-Vis) showed that the PANI synthesized using a surfactant was in the emeraldine base form, as the washing process tends to decrease the doping level in the PANI backbone. Our scanning electron microscopy analysis showed that the optimized synthesis parameters produced colloidal PANI with an average particle size of 695 nm. This higher aspect ratio explained the higher conductivity of nanosized PANI compared to micron-sized PANI. Following the chronological steps to determine the optimal parameters produced a nanosized PANI powder. The nanosized PANI had higher conductivity than the micron-sized PANI because of its higher aspect ratio. When PANI is synthesized in smaller particle sizes, it has higher conductivity. Atomic force microscopy analysis showed that the current flow is higher across a 5 µm2 scanned area of nanosized PANI because it has a larger surface area. Thus, more sites for the current to flow through were present on the nanosized PANI particles.

Schlagwörter

Stichwörter der Autor:innen

PANIcharacterizationdispersionparticle sizepolymerization

Autor:innen und Institutionen

  • Malaysian Institute of Chemical and Bioengineering Technology, Universiti Kuala Lumpur (UniKL), Alor Gajah 78000, Melaka, Malaysia.
  • Centre for Sustainability of Ecosystem & Earth Resources (Pusat ALAM), Universiti Malaysia Pahang, Lebuh Persiaran Tun Khalil Yaakob, Gambang 26300, Pahang, Malaysia.
  • Department of Chemistry, Faculty of Science, Universiti Malaya, Kuala Lumpur 50603, Malaysia.
  • HICoE-Centre for Biofuel and Biochemical Research, Institute of Self-Sustainable Building, Fundamental and Applied Sciences Department, Universiti Teknologi Petronas (UTP), Seri Iskandar 32610, Perak, Malaysia.
  • Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis, Arau 02600, Perlis, Malaysia.
  • Polymer Science Program, Division of Physical Science, Faculty of Science, Prince of Songkla University, Hat-Yai 90110, Songkla, Thailand.

ORCID-Profile: Mohd Faizar Banjar, Fatin Najwa Joynal Abedin, Md Sohrab Hossain, Nor Afifah Khalil, Ahmad Naim Ahmad Yahaya, Muzafar Zulkifli

Förderung

  • Ministry of Higher Education

Zitieren

APA

Banjar, M. F., Joynal Abedin, F. N., Fizal, A. N. S., Muhamad Sarih, N., Hossain, M. S., Osman, H., Khalil, N. A., Ahmad Yahaya, A. N., & Zulkifli, M. (2023). Synthesis and Characterization of a Novel Nanosized Polyaniline. Polymers, 15(23), 4565. https://doi.org/10.3390/polym15234565

Vancouver

Banjar MF, Joynal Abedin FN, Fizal ANS, Muhamad Sarih N, Hossain MS, Osman H, et al. Synthesis and Characterization of a Novel Nanosized Polyaniline. Polymers. 2023;15(23):4565. doi:10.3390/polym15234565

BibTeX
@article{Banjar2023,
  author = {Banjar, Mohd Faizar and Joynal Abedin, Fatin Najwa and Fizal, Ahmad Noor Syimir and Muhamad Sarih, Norazilawati and Hossain, Md Sohrab and Osman, Hakimah and Khalil, Nor Afifah and Ahmad Yahaya, Ahmad Naim and Zulkifli, Muzafar},
  title = {Synthesis and Characterization of a Novel Nanosized Polyaniline},
  journal = {Polymers},
  year = {2023},
  volume = {15},
  number = {23},
  pages = {4565},
  doi = {10.3390/polym15234565}
}
Kostenlos starten →