Study on the Low-Temperature Pre-Desulfurization of Crumb Rubber-Modified Asphalt
Polymers · 11.05.2023 · 15 (10) · 2273
DOI: 10.3390/polym15102273 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 11.05.2023. Verfasst von Shibo Zhang und 5 weiteren Autor:innen. Beteiligte Einrichtung: Yunnan Key Laboratory of Disaster Reduction in Civil Engineering, Kunming 650500, China. Die Arbeit wurde bisher 17-mal zitiert (Crossref) und nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Major Science and Technology Special Project of Yunnan Provincial Department of Science and Technology - "Research and Development of Key Technologies for Scal…, Major Science and Technology Special Project of Yunnan Provincial Science and Technology Department.
Abstract (Originalsprache)
Waste tires can be ground as crumb rubber (CR) and incorporated into asphalt pavement for efficient resource utilization. However, due to its thermodynamic incompatibility with asphalt, CR cannot be uniformly dispersed in the asphalt mix. In order to address this issue, pretreating the CR with desulfurization is a common way to restore some of the properties of natural rubber. The main technique of desulfurization and degradation is dynamic desulfurization, requiring a high temperature that may lead to asphalt fires, aging, and the volatilization of light substances, generating toxic gases and resulting in environmental pollution. Therefore, a green and low-temperature controlled desulfurization technology is proposed in this study to exploit the maximum potential of CR desulfurization and obtain high-solubility “liquid waste rubber” (LWR) close to the ultimate regeneration level. In this work, LWR-modified asphalt (LRMA) with superior low-temperature performance and processability, stable storage, and less susceptibility to segregation was developed. Nevertheless, its rutting and deformation resistance deteriorated at high temperatures. The results showed that the proposed CR-desulfurization technology could produce LWR with 76.9% solubility at a low temperature of 160 °C, which is close to or even better than the finished products produced at the preparation temperature of TB technology, i.e., 220–280 °C.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Yunnan Key Laboratory of Disaster Reduction in Civil Engineering, Kunming 650500, China.
- Faculty of Civil Engineering and Mechanics, Kunming University of Science and Technology, Kunming 650500, China.
ORCID-Profile: Rongxin Guo, Yong Yan
Förderung
- Major Science and Technology Special Project of Yunnan Provincial Department of Science and Technology - "Research and Development of Key Technologies for Scal…
- Major Science and Technology Special Project of Yunnan Provincial Science and Technology Department
Zitieren
APA
Zhang, S., Yang, Y., Guo, R., Yan, Y., Huan, H., & Wan, B. (2023). Study on the Low-Temperature Pre-Desulfurization of Crumb Rubber-Modified Asphalt. Polymers, 15(10), 2273. https://doi.org/10.3390/polym15102273
Vancouver
Zhang S, Yang Y, Guo R, Yan Y, Huan H, Wan B. Study on the Low-Temperature Pre-Desulfurization of Crumb Rubber-Modified Asphalt. Polymers. 2023;15(10):2273. doi:10.3390/polym15102273
BibTeX
@article{Zhang2023,
author = {Zhang, Shibo and Yang, Yang and Guo, Rongxin and Yan, Yong and Huan, Haiyang and Wan, Bangwei},
title = {Study on the Low-Temperature Pre-Desulfurization of Crumb Rubber-Modified Asphalt},
journal = {Polymers},
year = {2023},
volume = {15},
number = {10},
pages = {2273},
doi = {10.3390/polym15102273}
}
EUVIMED