Polymer-Based Additive Manufacturing for Orthotic and Prosthetic Devices: Industry Outlook in Canada
Polymers · 17.03.2023 · 15 (6) · 1506
DOI: 10.3390/polym15061506 ↗Kurz gefasst
Übersichtsarbeit in der Zeitschrift Polymers, online erschienen am 17.03.2023. Verfasst von Chowdhury Sakib-Uz-Zaman und 1 weiteren Autor:innen. Beteiligte Einrichtung: Industrial Systems Engineering, Faculty of Engineering and Applied Science, University of Regina, Regina, SK S4S 0A2, Canada. Die Arbeit wurde bisher 39-mal zitiert (Crossref) und nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: NSERC I2I Market Assessment Grant, NSERC I2I Market Assessment.
Abstract (Originalsprache)
The conventional manufacturing methods for fabricating orthotic and prosthetic (O&P) devices have been in practice for a very long time. Recently, O&P service providers have started exploring different advanced manufacturing techniques. The objective of this paper is to perform a mini review on recent progress in the use of polymer-based additive manufacturing (AM) for O&P devices and to gather insights from the O&P professionals on the current practices and technologies and on the prospect of using AM techniques in this field. In our study, first, scientific articles on AM for O&P devices were studied. Then, twenty-two (22) interviews were conducted with O&P professionals from Canada. The primary focus was on five key areas: cost, material, design and fabrication efficiency, structural strength, functionality, and patient satisfaction. The cost of manufacturing the O&P devices using AM techniques is lower as compared to the conventional methods. O&P professionals expressed their concern over the materials and structural strength of the 3D-printed prosthetic devices. Published articles report comparable functionality and patient satisfaction for both O&P devices. AM also greatly improves design and fabrication efficiency. However, due to a lack of qualification standards for 3D printed O&P devices, 3D printing is being embraced more slowly in the O&P business than in other industries.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Industrial Systems Engineering, Faculty of Engineering and Applied Science, University of Regina, Regina, SK S4S 0A2, Canada.
ORCID-Profile: Mohammad Abu Hasan Khondoker
Förderung
- NSERC I2I Market Assessment Grant
- NSERC I2I Market Assessment
Zitieren
APA
Sakib-Uz-Zaman, C., & Khondoker, M. A. H. (2023). Polymer-Based Additive Manufacturing for Orthotic and Prosthetic Devices: Industry Outlook in Canada. Polymers, 15(6), 1506. https://doi.org/10.3390/polym15061506
Vancouver
Sakib-Uz-Zaman C, Khondoker MAH. Polymer-Based Additive Manufacturing for Orthotic and Prosthetic Devices: Industry Outlook in Canada. Polymers. 2023;15(6):1506. doi:10.3390/polym15061506
BibTeX
@article{SakibUzZaman2023,
author = {Sakib-Uz-Zaman, Chowdhury and Khondoker, Mohammad Abu Hasan},
title = {Polymer-Based Additive Manufacturing for Orthotic and Prosthetic Devices: Industry Outlook in Canada},
journal = {Polymers},
year = {2023},
volume = {15},
number = {6},
pages = {1506},
doi = {10.3390/polym15061506}
}
EUVIMED