EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Parametric Study and Electrocatalyst of Polymer Electrolyte Membrane (PEM) Electrolysis Performance

Adam Mohd Izhan Noor Azam, Ng Khai Li, Nurul Noramelya Zulkefli, Mohd Shahbudin Masdar iD, Edy Herianto Majlan, Nurul Akidah Baharuddin iD, Azran Mohd Zainoodin, Rozan Mohamad Yunus iD, Noor Shahirah Shamsul, Teuku Husaini, Siti Nur Amira Shaffee

Polymers · 21.01.2023 · 15 (3) · 560

DOI: 10.3390/polym15030560 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 21.01.2023. Verfasst von Adam Mohd Izhan Noor Azam und 10 weiteren Autor:innen. Beteiligte Einrichtung: Fuel Cell Institute, Universiti Kebangsaan Malaysia, Bangi 43600, Selangor, Malaysia. Die Arbeit wurde bisher 57-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Petronas (Malaysia), National University of Malaysia, Universiti Kebangsaan Malaysia.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

An investigation was conducted to determine the effects of operating parameters for various electrode types on hydrogen gas production through electrolysis, as well as to evaluate the efficiency of the polymer electrolyte membrane (PEM) electrolyzer. Deionized (DI) water was fed to a single-cell PEM electrolyzer with an active area of 36 cm2. Parameters such as power supply (50–500 mA/cm2), feed water flow rate (0.5–5 mL/min), water temperature (25−80 °C), and type of anode electrocatalyst (0.5 mg/cm2 PtC [60%], 1.5 mg/cm2 IrRuOx with 1.5 mg/cm2 PtB, 3.0 mg/cm2 IrRuOx, and 3.0 mg/cm2 PtB) were varied. The effects of these parameter changes were then analyzed in terms of the polarization curve, hydrogen flowrate, power consumption, voltaic efficiency, and energy efficiency. The best electrolysis performance was observed at a DI water feed flowrate of 2 mL/min and a cell temperature of 70 °C, using a membrane electrode assembly that has a 3.0 mg/cm2 IrRuOx catalyst at the anode side. This improved performance of the PEM electrolyzer is due to the reduction in activation as well as ohmic losses. Furthermore, the energy consumption was optimal when the current density was about 200 mA/cm2, with voltaic and energy efficiencies of 85% and 67.5%, respectively. This result indicates low electrical energy consumption, which can lower the operating cost and increase the performance of PEM electrolyzers. Therefore, the optimal operating parameters are crucial to ensure the ideal performance and durability of the PEM electrolyzer as well as lower its operating costs.

Schlagwörter

Stichwörter der Autor:innen

electrochemical reactionenergy efficiencyparametric studypolymer electrolyte membrane (PEM) electrolyzerwater electrolysis

Autor:innen und Institutionen

  • Fuel Cell Institute, Universiti Kebangsaan Malaysia, Bangi 43600, Selangor, Malaysia.
  • Department of Chemical & Process Engineering, Faculty of Engineering & Built Environment, Universiti Kebangsaan Malaysia, Bangi 43600, Selangor, Malaysia.
  • Petronas Research Sdn Bhd (PRSB), Jalan Ayer Hitam, Kawasan Institusi Bangi, Bandar Baru Bangi 43650, Selangor, Malaysia.

ORCID-Profile: Mohd Shahbudin Masdar, Nurul Akidah Baharuddin, Rozan Mohamad Yunus

Förderung

  • Petronas (Malaysia)
  • National University of Malaysia
  • Universiti Kebangsaan Malaysia

Zitieren

APA

Noor Azam, A. M. I., Li, N. K., Zulkefli, N. N., Masdar, M. S., Majlan, E. H., Baharuddin, N. A., Mohd Zainoodin, A., Mohamad Yunus, R., Shamsul, N. S., Husaini, T., & Shaffee, S. N. A. (2023). Parametric Study and Electrocatalyst of Polymer Electrolyte Membrane (PEM) Electrolysis Performance. Polymers, 15(3), 560. https://doi.org/10.3390/polym15030560

Vancouver

Noor Azam AMI, Li NK, Zulkefli NN, Masdar MS, Majlan EH, Baharuddin NA, et al. Parametric Study and Electrocatalyst of Polymer Electrolyte Membrane (PEM) Electrolysis Performance. Polymers. 2023;15(3):560. doi:10.3390/polym15030560

BibTeX
@article{NoorAzam2023,
  author = {Noor Azam, Adam Mohd Izhan and Li, Ng Khai and Zulkefli, Nurul Noramelya and Masdar, Mohd Shahbudin and Majlan, Edy Herianto and Baharuddin, Nurul Akidah and Mohd Zainoodin, Azran and Mohamad Yunus, Rozan and Shamsul, Noor Shahirah and Husaini, Teuku and Shaffee, Siti Nur Amira},
  title = {Parametric Study and Electrocatalyst of Polymer Electrolyte Membrane (PEM) Electrolysis Performance},
  journal = {Polymers},
  year = {2023},
  volume = {15},
  number = {3},
  pages = {560},
  doi = {10.3390/polym15030560}
}
Kostenlos starten →