Integrated Design and Fabrication of Refractive–Diffractive Hybrid Lenses for Myopia Control
Photonics · 21.06.2026 · 13 (6) · 603
DOI: 10.3390/photonics13060603 ↗Kurz gefasst
Fachartikel in der Zeitschrift Photonics, online erschienen am 21.06.2026. Verfasst von Chuang Li und 3 weiteren Autor:innen. Die Arbeit nennt 18 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Jilin Province Science and Technology Department.
Abstract (Originalsprache)
As the prevalence of myopia among adolescents continues to increase, the design and fabrication of myopia control lenses have become an important research direction in modern optics. Existing myopia control lenses mostly adopt purely refractive structures, which suffer from limited design freedom, insufficient chromatic aberration suppression, and relatively large lens thickness, thereby restricting further improvement of optical performance. This paper proposes a refractive–diffractive hybrid design and fabrication method for myopia control lenses. Centered on a harmonic diffractive optical element (HDOE), an optimization model is established to balance achromatization performance and fabrication feasibility. To address the challenges of small period width, tool shadow effect, and sensitivity to machining tolerances in diffractive lenses with large-aperture and high-additional-power, harmonic design is employed to increase the period width, thereby reducing fabrication difficulty and mitigating the influence of shadowing errors on diffraction efficiency. On this basis, two lenses with different phase structures are designed: one adopts a conventional diffractive correction phase to verify the role of HDOE in achromatization and edge-thickness reduction, while the other adopts a high-degree-of-freedom smooth phase to achieve a continuous multifocal visual effect. Both lenses are fabricated by single-point diamond turning (SPDT), and the effects of surface profile and machining parameters on performance are analyzed. Simulations and measurements show that the proposed method provides stable diffraction efficiency and effective chromatic aberration correction across the design band, while reducing the edge thickness by approximately 37.85% without additional thinning of the aspheric substrate. The results indicate that the refractive–diffractive hybrid design provides a feasible design and fabrication approach for functionally more complex myopia control lenses.
Förderung
- Jilin Province Science and Technology Department
Zitieren
APA
Li, C., Liu, C., Xue, C., & Dong, B. (2026). Integrated Design and Fabrication of Refractive–Diffractive Hybrid Lenses for Myopia Control. Photonics, 13(6), 603. https://doi.org/10.3390/photonics13060603
Vancouver
Li C, Liu C, Xue C, Dong B. Integrated Design and Fabrication of Refractive–Diffractive Hybrid Lenses for Myopia Control. Photonics. 2026;13(6):603. doi:10.3390/photonics13060603
BibTeX
@article{Li2026,
author = {Li, Chuang and Liu, Chongxing and Xue, Changxi and Dong, Bo},
title = {Integrated Design and Fabrication of Refractive–Diffractive Hybrid Lenses for Myopia Control},
journal = {Photonics},
year = {2026},
volume = {13},
number = {6},
pages = {603},
doi = {10.3390/photonics13060603}
}
EUVIMED