EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Optimization of Oxygen Pressure in HVOF Spraying for Enhanced Corrosion Resistance and Thermal Stability of Al-Cu-Fe Quasicrystalline Coatings

Dilnoza Baltabayeva iD, Sherzod Kurbanbekov, Ali Coruh iD, Lyaila Bayatanova, Sattarbek Bekbayev, Berik Kaldar iD, Diyar Patchakhanov iD

Nanomaterials · 23.06.2026 · 16 (13) · 790

DOI: 10.3390/nano16130790 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 23.06.2026. Verfasst von Dilnoza Baltabayeva und 6 weiteren Autor:innen. Beteiligte Einrichtung: International School of Engineering, D. Serikbayev East Kazakhstan State Technical University, Ust-Kamenogorsk 070004, Kazakhstan. Die Arbeit nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Higher Education of the Republic of Kazakhstan, the Committee of Science of the Ministry of Science and Higher Education of the Republic of Kazakhstan.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Al-Cu-Fe quasicrystalline coatings were deposited on AISI 321 stainless steel substrates by high-velocity oxy-fuel (HVOF) spraying at oxygen pressures of 3.0, 3.5, and 4.0 bar. The influence of oxygen pressure on the phase composition, microstructure, porosity, corrosion behavior, thermal stability, and microhardness of the coatings was investigated using X-ray diffraction (XRD), scanning electron microscopy coupled with energy-dispersive spectroscopy (SEM/EDS), ImageJ porosity analysis, electrochemical corrosion testing in 3.5 wt.% NaCl solution, simultaneous thermal analysis (TGA/DSC), and microhardness measurements. XRD analysis revealed the formation of quasicrystalline-related intermetallic phases together with Al, Fe3Al13, FeAl, Fe3O4, CuFe2O4, Cu2O, and CuO phases. The coating deposited at 3.5 bar exhibited the lowest porosity (5.37%), the most homogeneous microstructure, and the largest residual coating thickness after corrosion testing. SEM and EDS analyses indicated that corrosion preferentially initiated at pores, splat boundaries, and phase interfaces, while the coating produced at 3.5 bar demonstrated the most stable surface condition after exposure to a 3.5 wt.% NaCl solution. Thermal analysis showed that all coatings remained stable up to 900 °C. Sample (a) exhibited the lowest mass loss and the highest thermal stability, whereas sample (b) demonstrated the most favorable combination of structural integrity, phase ordering, coating density, corrosion-related performance, and thermal stability. Microhardness values of the coatings ranged from 754 to 778 HV, significantly exceeding that of the AISI 321 substrate. The results demonstrate that oxygen pressure is a critical parameter controlling the microstructure and functional properties of HVOF-sprayed Al-Cu-Fe coatings, with 3.5 bar providing the most balanced set of properties.

Schlagwörter

Stichwörter der Autor:innen

Al-Cu-FeHVOFSEMTGAcorrosion

Autor:innen und Institutionen

  • International School of Engineering, D. Serikbayev East Kazakhstan State Technical University, Ust-Kamenogorsk 070004, Kazakhstan.
  • The Research Institute "Natural Sciences, Nanotechnology and New Materials", Khoja Akhmet Yassawi International Kazakh-Turkish University, Turkestan 161200, Kazakhstan.
  • Department of Physics, Faculty of Science, University of Sakarya, 54150 Sakarya, Turkey.

ORCID-Profile: Dilnoza Baltabayeva, Ali Coruh, Berik Kaldar, Diyar Patchakhanov

Förderung

  • Ministry of Science and Higher Education of the Republic of Kazakhstan
  • the Committee of Science of the Ministry of Science and Higher Education of the Republic of Kazakhstan

Zitieren

APA

Baltabayeva, D., Kurbanbekov, S., Coruh, A., Bayatanova, L., Bekbayev, S., Kaldar, B., & Patchakhanov, D. (2026). Optimization of Oxygen Pressure in HVOF Spraying for Enhanced Corrosion Resistance and Thermal Stability of Al-Cu-Fe Quasicrystalline Coatings. Nanomaterials, 16(13), 790. https://doi.org/10.3390/nano16130790

Vancouver

Baltabayeva D, Kurbanbekov S, Coruh A, Bayatanova L, Bekbayev S, Kaldar B, et al. Optimization of Oxygen Pressure in HVOF Spraying for Enhanced Corrosion Resistance and Thermal Stability of Al-Cu-Fe Quasicrystalline Coatings. Nanomaterials. 2026;16(13):790. doi:10.3390/nano16130790

BibTeX
@article{Baltabayeva2026,
  author = {Baltabayeva, Dilnoza and Kurbanbekov, Sherzod and Coruh, Ali and Bayatanova, Lyaila and Bekbayev, Sattarbek and Kaldar, Berik and Patchakhanov, Diyar},
  title = {Optimization of Oxygen Pressure in HVOF Spraying for Enhanced Corrosion Resistance and Thermal Stability of Al-Cu-Fe Quasicrystalline Coatings},
  journal = {Nanomaterials},
  year = {2026},
  volume = {16},
  number = {13},
  pages = {790},
  doi = {10.3390/nano16130790}
}
Kostenlos starten →