EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Effect of the Back Surface Field on the Performance of Cu3SnS4 Thin Film Solar Cell Modeled Using SCAPS-1D Software

Serap Yiğit Gezgin, Şilan Baturay iD, Shrouk E Zaki iD, Hamdi Şükür Kiliç

Nanomaterials · 13.05.2026 · 16 (10) · 597

DOI: 10.3390/nano16100597 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 13.05.2026. Verfasst von Serap Yiğit Gezgin und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Physics, Faculty of Science, Selcuk University, 42030 Selcuk, Konya, Turkey. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 68 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, the PV performance of Au/BSF/CTS/CdS/i-ZnO/ITO thin-film solar cell (TFC) structure was systematically investigated using SCAPS-1D software. The effects of several critical parameters, including interface defect density, recombination mechanisms, absorber defect density, operating temperature, parasitic resistances, and different back surface field (BSF) layers, were comprehensively analyzed. The SCAPS-1D software results reveal that the photovoltaic performance is highly sensitive to the defect density at the absorber layer interface. When the interface defect density increased from 1012 cm−3 to 1016 cm−3, the open-circuit voltage (VOC) decreased from approximately 0.68 V to 0.45 V, while the power conversion efficiency (PCE) declined from nearly 19% to about 7%. Similarly, an increase in absorber defect density enhanced the Shockley–Read–Hall recombination rate, thereby reducing carrier lifetime and significantly deteriorating PV parameters. The influence of radiative and Auger recombination (BAuger) processes was also examined, revealing that higher recombination coefficients lead to substantial reductions in current density and efficiency due to increased carrier losses. Furthermore, the impact of parasitic resistances was evaluated, demonstrating that decrease the series resistance from 9.5 Ω·cm2 to 0.5 Ω·cm2 increased the fill factor (FF) from about 48% to nearly 78%, while the device efficiency improved to approximately 32%. In addition to these parameters, particular emphasis was placed on the investigation of different BSF materials to enhance back contact performance. Various BSF layers, including SnS, PbS, V2O5, and Sb2S3, were examined to improve band alignment and suppress minority carrier recombination at the rear interface. Among these materials, the SnS BSF layer provided the most favorable band alignment with the CTS absorber, leading to a notable improvement in PV parameters and increasing the efficiency to approximately 25%. Overall, the results demonstrate that optimizing defect densities, recombination mechanisms, parasitic resistances, and especially the selection of appropriate BSF materials plays a crucial role in improving the performance of CTS-based TFCs.

Schlagwörter

Stichwörter der Autor:innen

BSFCTSSCASP-1Dsolar cellthin film

Autor:innen und Institutionen

  • Department of Physics, Faculty of Science, Selcuk University, 42030 Selcuk, Konya, Turkey.
  • Department of Physics, Faculty of Science, Dicle University, 21280 Sur, Diyarbakir, Turkey.
  • Optics Research Group, Department of Imaging Physics, Faculty of Applied Sciences, Delft University of Technology, Mekelweg 2, 2628 CD Delft, The Netherlands.
  • Department of Nanotechnology and Advanced Materials, Graduate School of Applied and Natural Science, Selcuk University, 42030 Selcuk, Konya, Turkey.
  • Department of Metallurgy and Materials Engineering, Faculty of Engineering, University of Dokuz Eylul, 35220 Konak, Izmir, Turkey.

ORCID-Profile: Şilan Baturay, Shrouk E Zaki

Zitieren

APA

Gezgin, S. Y., Baturay, Ş., Zaki, S. E., & Kiliç, H. Ş. (2026). The Effect of the Back Surface Field on the Performance of Cu3SnS4 Thin Film Solar Cell Modeled Using SCAPS-1D Software. Nanomaterials, 16(10), 597. https://doi.org/10.3390/nano16100597

Vancouver

Gezgin SY, Baturay Ş, Zaki SE, Kiliç HŞ. The Effect of the Back Surface Field on the Performance of Cu3SnS4 Thin Film Solar Cell Modeled Using SCAPS-1D Software. Nanomaterials. 2026;16(10):597. doi:10.3390/nano16100597

BibTeX
@article{Gezgin2026,
  author = {Gezgin, Serap Yiğit and Baturay, Şilan and Zaki, Shrouk E and Kiliç, Hamdi Şükür},
  title = {The Effect of the Back Surface Field on the Performance of Cu3SnS4 Thin Film Solar Cell Modeled Using SCAPS-1D Software},
  journal = {Nanomaterials},
  year = {2026},
  volume = {16},
  number = {10},
  pages = {597},
  doi = {10.3390/nano16100597}
}
Kostenlos starten →