EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

High-Temperature Properties of Hot Mix Asphalt Modified with Different Nanomaterials

Yousuf M Hamed AlHamdo iD, Amjad H Khalil Albayati iD, Mazen J Al-Kheetan iD

Nanomaterials · 08.12.2025 · 15 (24) · 1845

DOI: 10.3390/nano15241845 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 08.12.2025. Verfasst von Yousuf M Hamed AlHamdo und 2 weiteren Autor:innen. Beteiligte Einrichtung: Civil Engineering Department, University of Baghdad, Baghdad 10070, Iraq. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 81 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Rutting is a predominant distress in asphalt pavements, particularly in hot climatic regions. This study systematically investigated the high-temperature performance of hot mix asphalt modified with five nanomaterials, namely, nano-silica (NS), nano-alumina (NA), nano-titanium (NT), nano-zinc (NZ), and carbon nanotubes (CNTs), under consistent laboratory conditions. Modification dosages were selected up to 10% for NS, NA, and NT, and up to 5% for NZ and CNTs. The experimental methodology comprised the following: (i) binder rheological characterization through rotational viscosity, G*/sinδ, and multiple stress creep recovery (MSCR) to quantify rutting susceptibility; (ii) chemical and microstructural assessments using Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM); (iii) mixture-level evaluation via repeated-load axial testing coupled with digital image correlation (DIC) to monitor permanent microstrain evolution; and (iv) rutting performance over a 20-year period using the VESYS 5W predictive model. A cost–performance analysis was further incorporated to assess the economic viability of each nanomaterial. The results demonstrated that nanomodification substantially improved rutting resistance, consistent with reductions in non-recoverable creep compliance and permanent microstrain. Among additives, the 8% NS mixture exhibited the most favorable performance, maintaining a present serviceability index (PSI) of 2.5 after 20 years, whereas the un-modified mixture dropped below the failure threshold within a few years. These findings confirm that nanomaterial selection and dosage can meaningfully enhance the structural and performance of asphalt pavements.

Schlagwörter

Stichwörter der Autor:innen

DICMSCRVESYSasphaltnanomaterialpermanent deformation

Autor:innen und Institutionen

  • Civil Engineering Department, University of Baghdad, Baghdad 10070, Iraq.
  • Civil and Environmental Engineering Department, College of Engineering, Mutah University, Karak 61710, Jordan.

ORCID-Profile: Yousuf M Hamed AlHamdo, Amjad H Khalil Albayati, Mazen J Al-Kheetan

Zitieren

APA

AlHamdo, Y. M. H., Albayati, A. H. K., & Al-Kheetan, M. J. (2025). High-Temperature Properties of Hot Mix Asphalt Modified with Different Nanomaterials. Nanomaterials, 15(24), 1845. https://doi.org/10.3390/nano15241845

Vancouver

AlHamdo YMH, Albayati AHK, Al-Kheetan MJ. High-Temperature Properties of Hot Mix Asphalt Modified with Different Nanomaterials. Nanomaterials. 2025;15(24):1845. doi:10.3390/nano15241845

BibTeX
@article{AlHamdo2025,
  author = {AlHamdo, Yousuf M Hamed and Albayati, Amjad H Khalil and Al-Kheetan, Mazen J},
  title = {High-Temperature Properties of Hot Mix Asphalt Modified with Different Nanomaterials},
  journal = {Nanomaterials},
  year = {2025},
  volume = {15},
  number = {24},
  pages = {1845},
  doi = {10.3390/nano15241845}
}
Kostenlos starten →