Improving Photovoltaic Performance of Hybrid Organic-Inorganic MAGeI3 Perovskite Solar Cells via Numerical Optimization of Carrier Transport Materials (HTLs/ETLs)
Nanomaterials · 31.07.2023 · 13 (15) · 2221
DOI: 10.3390/nano13152221 ↗Kurz gefasst
Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 31.07.2023. Verfasst von Tariq AlZoubi und 4 weiteren Autor:innen. Beteiligte Einrichtung: College of Engineering and Technology, American University of the Middle East, Egaila 54200, Kuwait. Die Arbeit wurde bisher 55-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: American University of the Middle East (AUM), Kuwait.
Abstract (Originalsprache)
In this study, a hybrid organic–inorganic perovskite solar cell (PSC) based on methylammonium germanium triiodide (MAGeI3), which is composed of methylammonium (CH3NH3+) cations and germanium triiodide (GeI3−) anions, has been numerically studied using SCAPS-1d codes. An extensive investigation of various electron transport layers (ETLs) and hole transport layers (HTLs) was conducted to identify the most optimal device configuration. The FTO/ZnOS/MAGeI3/PEDOT-WO3 structure performed the highest efficiency of all combinations tested, with an impressive optimized efficiency of 15.84%. This configuration exhibited a Voc of 1.38 V, Jsc of 13.79 mA/cm2, and FF of 82.58%. J-V characteristics and external quantum efficiency (EQE) measurements indicate that this device offers superior performance, as it has reduced current leakage, improved electron and hole extraction characteristics, and reduced trap-assisted interfacial recombination. Optimum device performance was achieved at active layer thickness of 560 nm. These findings may also serve as a basis for developing lightweight and ultra-thin solar cells, in addition to improving overall efficiency. Furthermore, a comprehensive correlation study was conducted to evaluate the optimum thickness and doping level for both ZnOS-ETL and PEDOT-WO3-HTL. The photovoltaic performance parameters of the FTO/ZnOS/MAGeI3/PEDOT-WO3 structure were analyzed over a wide temperature range (275 K to 450 K). The structure exhibited stable performance at elevated operating temperatures up to 385 K, with only minimal degradation in PCE of approximately 0.42%. Our study underscores the promise of utilizing cost-effective and long-term stability materials like ZnOS and PEDOT-WO3 alongside the toxic-free MAGeI3 perovskite. This combination exhibits significant potential for eco-friendly PSC, paving the way for the development of highly efficient ultra-thin PSC.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- College of Engineering and Technology, American University of the Middle East, Egaila 54200, Kuwait.
- Department of Physics, School of Basic Sciences and Humanities, German Jordanian University, Amman 11180, Jordan.
- Bio-Medical Physics Laboratory, Department of Physics, Jordan University of Science and Technology, Irbid 22110, Jordan.
- MEU Research Unit, Middle East University, Amman 11831, Jordan.
ORCID-Profile: Tariq AlZoubi, Bachar Mourched
Förderung
- American University of the Middle East (AUM), Kuwait
Zitieren
APA
AlZoubi, T., Mourched, B., Al Gharram, M., Makhadmeh, G., & Abu Noqta, O. (2023). Improving Photovoltaic Performance of Hybrid Organic-Inorganic MAGeI3 Perovskite Solar Cells via Numerical Optimization of Carrier Transport Materials (HTLs/ETLs). Nanomaterials, 13(15), 2221. https://doi.org/10.3390/nano13152221
Vancouver
AlZoubi T, Mourched B, Al Gharram M, Makhadmeh G, Abu Noqta O. Improving Photovoltaic Performance of Hybrid Organic-Inorganic MAGeI3 Perovskite Solar Cells via Numerical Optimization of Carrier Transport Materials (HTLs/ETLs). Nanomaterials. 2023;13(15):2221. doi:10.3390/nano13152221
BibTeX
@article{AlZoubi2023,
author = {AlZoubi, Tariq and Mourched, Bachar and Al Gharram, Mahmoud and Makhadmeh, Ghaseb and Abu Noqta, Osama},
title = {Improving Photovoltaic Performance of Hybrid Organic-Inorganic MAGeI3 Perovskite Solar Cells via Numerical Optimization of Carrier Transport Materials (HTLs/ETLs)},
journal = {Nanomaterials},
year = {2023},
volume = {13},
number = {15},
pages = {2221},
doi = {10.3390/nano13152221}
}
EUVIMED