Cu/TiO2 Derived from Cu-Doped MIL-125 for Enhanced Photocatalytic CO2-to-CH4 Conversion
Molecules · 01.07.2026 · 31 (13) · 2304
DOI: 10.3390/molecules31132304 ↗Kurz gefasst
Fachartikel in der Zeitschrift Molecules, online erschienen am 01.07.2026. Verfasst von Haopeng Cui und 7 weiteren Autor:innen. Beteiligte Einrichtung: School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai 200093, China. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Innovation Program of Shanghai Municipal Education Commission, Shanghai Class IV Peak Disciplinary Development Program.
Abstract (Originalsprache)
Photocatalytic CO2 reduction into CH4 is a promising route for solar fuel production, but its efficiency is still limited by poor charge separation, insufficient CO2 activation, and sluggish multi-electron transfer kinetics. Herein, Cu-modified TiO2 (Cu/TiO2) was prepared by calcining a Cu-modified defective MIL-125(Ti) precursor, denoted as Cu-MIL-125, through a temperature-controlled calcination strategy. The effects of calcination temperature on the structural evolution, surface chemical states, interfacial charge transport, and CO2 photoreduction performance were examined. These results indicated that the Cu/TiO2 was successfully prepared, while the crystallinity, porous structure, and interfacial electronic properties of Cu/TiO2 were strongly dependent on the calcination temperature. Among the obtained samples, the Cu/TiO2 sample obtained by calcining Cu-MIL-125 at 450 °C (450 Cu/TiO2) exhibited the highest CH4 formation rate, reaching 15.90 μmol g−1 h−1, corresponding to an approximately 9.8-fold enhancement over TiO2 calcined from defective MIL-125(Ti) at 450 °C, together with a high CH4 selectivity of 93.05%. Control experiments and 13CO2 isotope-labeling tests confirmed that the detected carbon-containing products were generated from CO2 under photocatalytic conditions. In situ diffuse reflectance infrared Fourier transform spectroscopy measurements further revealed the formation of carbonate, bicarbonate and hydrogenated carbon-containing intermediates during the reaction. This work offers a practical route for constructing metal–organic framework-derived Cu/TiO2 photocatalysts for selective CH4 production from CO2.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai 200093, China.
- Shanghai Noncarbon Energy Conversion and Utilization Institute, Shanghai 200240, China.
- College of Smart Energy, Shanghai Jiao Tong University, Shanghai 200240, China.
- Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China.
ORCID-Profile: Haopeng Cui, Xiaodong Zhang
Förderung
- National Natural Science Foundation of China
- Innovation Program of Shanghai Municipal Education Commission
- Shanghai Class IV Peak Disciplinary Development Program
Zitieren
APA
Cui, H., Li, Z., Huang, S., Zhang, T., Zhang, X., Zhang, Z., Lei, J., & Liu, N. (2026). Cu/TiO2 Derived from Cu-Doped MIL-125 for Enhanced Photocatalytic CO2-to-CH4 Conversion. Molecules, 31(13), 2304. https://doi.org/10.3390/molecules31132304
Vancouver
Cui H, Li Z, Huang S, Zhang T, Zhang X, Zhang Z, et al. Cu/TiO2 Derived from Cu-Doped MIL-125 for Enhanced Photocatalytic CO2-to-CH4 Conversion. Molecules. 2026;31(13):2304. doi:10.3390/molecules31132304
BibTeX
@article{Cui2026,
author = {Cui, Haopeng and Li, Zhiying and Huang, Siyu and Zhang, Tianyi and Zhang, Xiaodong and Zhang, Zhongxiao and Lei, Jianqiu and Liu, Ning},
title = {Cu/TiO2 Derived from Cu-Doped MIL-125 for Enhanced Photocatalytic CO2-to-CH4 Conversion},
journal = {Molecules},
year = {2026},
volume = {31},
number = {13},
pages = {2304},
doi = {10.3390/molecules31132304}
}
EUVIMED