EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

BaTiO3 Functional Perovskite as Photocathode in Microbial Fuel Cells for Energy Production and Wastewater Treatment

Noureddine Touach, Abdellah Benzaouak iD, Jamil Toyir iD, Youssra El Hamdouni, Mohammed El Mahi, El Mostapha Lotfi, Najoua Labjar iD, Mohamed Kacimi, Leonarda Francesca Liotta iD

Molecules · 2023

DOI: 10.3390/molecules28041894 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Molecules, 2023. Verfasst von Noureddine Touach und 8 weiteren Autor:innen. Beteiligte Einrichtung: Laboratory of Spectroscopy, Molecular Modelling, Materials, Nanomaterials, Water and Environment, Environmental Materials Team, ENSAM, Mohammed V Uni…. Hauptthemen laut MEDLINE: Bioelectric Energy Sources, Water Purification. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Moroccan Ministry of Higher Education, Scientific Research and Innovation, OCP Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microbial fuel cells (MFCs) provide new opportunities for the sustainable production of energy, converting organic matter into electricity through microorganisms. Moreover, MFCs play an important role in remediation of environmental pollutants from wastewater with power generation. This work focuses on the evaluation of ferroelectric perovskite materials as a new class of non-precious photocatalysts for MFC cathode construction. Nanoparticles of BaTiO3 (BT) were prepared and tested in a microbial fuel cell (MFC) as photocathode catalytic components. The catalyst phases were synthesized, identified and characterized by XRD, SEM, UV–Vis absorption spectroscopy, P-E hysteresis and dielectric measurements. The maximum absorption of BT nanoparticles was recorded at 285 nm and the energy gap (Eg) was estimated to be 3.77 eV. Photocatalytic performance of cathodes coated with BaTiO3 was measured in a dark environment and then in the presence of a UV–visible (UV–Vis) light source, using a mixture of dairy industry and domestic wastewater as a feedstock for the MFCs. The performance of the BT cathodic component is strongly dependent on the presence of UV–Vis irradiation. The BT-based cathode functioning under UV–visible light improves the maximum power densities and the open circuit voltage (OCV) of the MFC system. The values increased from 64 mW m−2 to 498 mW m−2 and from 280 mV to 387 mV, respectively, showing that the presence of light effectively improved the photocatalytic activity of this ceramic. Furthermore, the MFCs operating under optimal conditions were able to reduce the chemical oxygen demand load in wastewater by 90% (initial COD = 2500 mg L−1).

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Bioelectric Energy SourcesWater PurificationWastewaterElectricityElectrodesTitaniumBarium CompoundsOxidesCalcium Compounds

Stichwörter der Autor:innen

BaTiO3chemical oxygen demandmicrobial fuel cellperovskitephotocathodewastewater treatment

Substanzen

Wastewaterbarium titanate(IV)TitaniumBarium CompoundsperovskiteOxidesCalcium Compounds

Autor:innen und Institutionen

  • Laboratory of Spectroscopy, Molecular Modelling, Materials, Nanomaterials, Water and Environment, Environmental Materials Team, ENSAM, Mohammed V University in Rabat, Avenue des Forces Armées Royales, Rabat B.P. 6207, M…
  • Laboratoire des Procédés, Matériaux et Environnement (LPME), Faculté Polydisciplinaire (FP-Taza), Faculté des Sciences Et Techniques de Fès (FST-Fès), Université Sidi Mohammed Ben Abdellah, Taza B.P. 1223, Morocco.
  • Laboratory of Physical Chemistry of Materials, Catalysis and Environment, Department of Chemistry, Faculty of Sciences, Mohammed V University in Rabat, Rabat B.P. 1014, Morocco.
  • Istituto per lo Studio dei Materiali Nanostrutturati (ISMN)-CNR, via Ugo La Malfa, 153, 90146 Palermo, Italy.

ORCID-Profile: Abdellah Benzaouak, Jamil Toyir, Najoua Labjar, Leonarda Francesca Liotta

Förderung

  • Moroccan Ministry of Higher Education, Scientific Research and Innovation
  • OCP Foundation

Zitieren

APA

Touach, N., Benzaouak, A., Toyir, J., El Hamdouni, Y., El Mahi, M., Lotfi, E. M., Labjar, N., Kacimi, M., & Liotta, L. F. (2023). BaTiO3 Functional Perovskite as Photocathode in Microbial Fuel Cells for Energy Production and Wastewater Treatment. Molecules. https://doi.org/10.3390/molecules28041894

Vancouver

Touach N, Benzaouak A, Toyir J, El Hamdouni Y, El Mahi M, Lotfi EM, et al. BaTiO3 Functional Perovskite as Photocathode in Microbial Fuel Cells for Energy Production and Wastewater Treatment. Molecules. 2023. doi:10.3390/molecules28041894

BibTeX
@article{Touach2023,
  author = {Touach, Noureddine and Benzaouak, Abdellah and Toyir, Jamil and El Hamdouni, Youssra and El Mahi, Mohammed and Lotfi, El Mostapha and Labjar, Najoua and Kacimi, Mohamed and Liotta, Leonarda Francesca},
  title = {BaTiO3 Functional Perovskite as Photocathode in Microbial Fuel Cells for Energy Production and Wastewater Treatment},
  journal = {Molecules},
  year = {2023},
  doi = {10.3390/molecules28041894}
}
Kostenlos starten →