Selective Dissolution and Pore-Structure Modification of Dolostone Under Paired Temperature-Pressure Conditions: Insights from Continuous-Flow Acetic-Acid Experiments
Minerals · 28.10.2026 · 16 (11) · 1115
DOI: 10.3390/min16111115 ↗Kurz gefasst
Fachartikel in der Zeitschrift Minerals, online erschienen am 28.10.2026. Verfasst von Xiaotian Li und 8 weiteren Autor:innen. Die Arbeit nennt 59 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: PetroChina Hangzhou Institute of Petrole-um Geology, Oil & Gas Major Project, National Natural Science Foundation of China.
Abstract (Originalsprache)
Deep to ultra-deep dolostone reservoirs may be substantially modified by organic-acid-bearing fluids, but the relationship between fluid-phase chemical signals and residual pore-system modification under paired temperature–pressure (T–P) conditions remains insufficiently constrained. To address this gap, continuous-flow acetic-acid dissolution experiments were conducted using Cambrian Longwangmiao Formation dolostone from the Sichuan Basin, China, as the experimental material. A 3.85 mL L−1 acetic acid solution was applied under five paired T–P conditions ranging from 20 °C/0.1 MPa to 200 °C/70 MPa to simulate coupled subsurface environments. Coordinate-guided SEM observations, quasi-steady-state effluent Ca2+ and Mg2+ concentrations, gravimetric mass loss, low-temperature N2 adsorption, and FHH fractal analysis were integrated to characterize the chemical and pore-structure responses. The results show that dissolution was strongly selective and concentrated at surface defects, cleavage-related features, crystal margins, intercrystalline contacts, and pre-existing pores or microfractures. Mean quasi-steady-state Ca2+ + Mg2+ concentrations varied non-monotonically, reaching a maximum of 31.86 × 10−3 mol L−1 at 60 °C/15 MPa and a minimum of 18.92 × 10−3 mol L−1 at 140 °C/65 MPa. At 60 °C/15 MPa and 100 °C/30 MPa, SEM showed local pore widening, whereas bulk N2-accessible pore volume and BET surface area changed little. At 200 °C/70 MPa, mass loss reached 4.97%, BET surface area increased from 0.1761 to 0.5192 m2 g−1, total N2-accessible pore volume increased from 0.001176 to 0.001940 cm3 g−1, and average pore diameter decreased from 26.04 to 12.99 nm. Taken together, these results demonstrate a partial decoupling among the chemical, gravimetric, and residual pore-structure responses across the paired T–P conditions. This finding indicates that effluent chemistry alone does not fully characterize solid-phase pore modification in an open continuous-flow system.
Förderung
- PetroChina Hangzhou Institute of Petrole-um Geology
- Oil & Gas Major Project
- National Natural Science Foundation of China
Zitieren
APA
Li, X., She, M., Jiang, H., Zhao, J., Li, L., Yin, F., Zhou, G., Jia, H., & Liang, J. (2026). Selective Dissolution and Pore-Structure Modification of Dolostone Under Paired Temperature-Pressure Conditions: Insights from Continuous-Flow Acetic-Acid Experiments. Minerals, 16(11), 1115. https://doi.org/10.3390/min16111115
Vancouver
Li X, She M, Jiang H, Zhao J, Li L, Yin F, et al. Selective Dissolution and Pore-Structure Modification of Dolostone Under Paired Temperature-Pressure Conditions: Insights from Continuous-Flow Acetic-Acid Experiments. Minerals. 2026;16(11):1115. doi:10.3390/min16111115
BibTeX
@article{Li2026,
author = {Li, Xiaotian and She, Min and Jiang, Huachuan and Zhao, Jie and Li, Luping and Yin, Fuying and Zhou, Gang and Jia, Huanhuan and Liang, Jintong},
title = {Selective Dissolution and Pore-Structure Modification of Dolostone Under Paired Temperature-Pressure Conditions: Insights from Continuous-Flow Acetic-Acid Experiments},
journal = {Minerals},
year = {2026},
volume = {16},
number = {11},
pages = {1115},
doi = {10.3390/min16111115}
}
EUVIMED