EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

FEA-Guided Design and Experimental Validation of ZnO-Based Surface Acoustic Wave Biosensor with Au Sensing Layer for Label-Free EGFR L858R Mutation Detection

Thita Sonklin, Shivakumar Chedurupalli, Dhanunjaya Munthala, Nutthaphat Luangjiranotai, Pattanaphong Janphuang, James K. C. Raju, Soodkhet Pojprapai, Sanong Suksaweang

Micro · 10.08.2026 · 6 (3) · 64

DOI: 10.3390/micro6030064 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Micro, online erschienen am 10.08.2026. Verfasst von Thita Sonklin und 7 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Suranaree University of Technology.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the acoustic response of ZnO-based SAW devices fabricated on ZnO/Si and ZnO/SiO2/Si substrates through a combined finite element analysis and experimental approach. Two-dimensional FEA was used to analyze scattering parameters, three-dimensional FEA was used to determine eigenfrequencies and mode shapes, and ZnO thin films were deposited by RF magnetron sputtering with interdigital transducers defined by UV lithography. The ZnO/SiO2/Si device exhibited Rayleigh and Sezawa-type mode resonances at 145 MHz (4350 m/s) and 234 MHz (7020 m/s), respectively, in close agreement with simulation, while the ZnO/Si device resonated at 166 MHz with a phase velocity of 4980 m/s. Incorporation of the Au sensing layer improved signal transmission by approximately 2 dB, consistent with modeling predictions. For biosensing evaluation, the device was functionalized with a thiolated ssDNA probe targeting the EGFR L858R point mutation, a clinically relevant lung cancer biomarker. Probe immobilization and target hybridization were confirmed by contact angle measurements and resonance frequency shifts, with the sensor demonstrating a linear detection range of 0.1 to 0.6 µM and LOD of 0.09 µM. These findings establish an integrated framework of acoustic modeling, microfabrication, and biofunctionalization for ZnO-based SAW biosensors toward label-free nucleic acid detection.

Förderung

  • Suranaree University of Technology

Zitieren

APA

Sonklin, T., Chedurupalli, S., Munthala, D., Luangjiranotai, N., Janphuang, P., Raju, J. K. C., Pojprapai, S., & Suksaweang, S. (2026). FEA-Guided Design and Experimental Validation of ZnO-Based Surface Acoustic Wave Biosensor with Au Sensing Layer for Label-Free EGFR L858R Mutation Detection. Micro, 6(3), 64. https://doi.org/10.3390/micro6030064

Vancouver

Sonklin T, Chedurupalli S, Munthala D, Luangjiranotai N, Janphuang P, Raju JKC, et al. FEA-Guided Design and Experimental Validation of ZnO-Based Surface Acoustic Wave Biosensor with Au Sensing Layer for Label-Free EGFR L858R Mutation Detection. Micro. 2026;6(3):64. doi:10.3390/micro6030064

BibTeX
@article{Sonklin2026,
  author = {Sonklin, Thita and Chedurupalli, Shivakumar and Munthala, Dhanunjaya and Luangjiranotai, Nutthaphat and Janphuang, Pattanaphong and Raju, James K. C. and Pojprapai, Soodkhet and Suksaweang, Sanong},
  title = {FEA-Guided Design and Experimental Validation of ZnO-Based Surface Acoustic Wave Biosensor with Au Sensing Layer for Label-Free EGFR L858R Mutation Detection},
  journal = {Micro},
  year = {2026},
  volume = {6},
  number = {3},
  pages = {64},
  doi = {10.3390/micro6030064}
}
Kostenlos starten →