EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Process of Fabricating Hyaluronic Acid-Based Milli-to-Microneedles Using the Bi-Directional Drawing Method

Joon-Koo Kang, Kihak Lee, Yein Choi, Se-Gie Kim, Bonghwan Kim

Micro · 01.05.2025 · 5 (2) · 22

DOI: 10.3390/micro5020022 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Micro, online erschienen am 01.05.2025. Verfasst von Joon-Koo Kang und 4 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 25 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Daegu Catholic University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microneedles (MNs) have emerged as a promising tool for pain-free drug delivery, offering an alternative to traditional syringe-based methods. Among various types of MNs, dissolving microneedles fabricated from hyaluronic acid (HA) have gained attention due to their biocompatibility and ability to deliver drugs with minimal discomfort. However, conventional HA MN fabrication techniques often limit needle lengths to a few hundred micrometers, which is insufficient for deeper drug penetration. This study introduces a novel fabrication method using bidirectional drawing lithography to extend the length of HA-based MNs. By adjusting the viscosity of HA solutions and employing a controlled pulling process, we demonstrate the feasibility of producing MNs with lengths ranging from millimeters to micrometers. An average height of 15 mm and tip diameters of approximately 80 μm were successfully produced. This advancement enhances the potential of HA MNs for transdermal drug delivery and interstitial fluid sampling.

Förderung

  • Daegu Catholic University

Zitieren

APA

Kang, J., Lee, K., Choi, Y., Kim, S., & Kim, B. (2025). Process of Fabricating Hyaluronic Acid-Based Milli-to-Microneedles Using the Bi-Directional Drawing Method. Micro, 5(2), 22. https://doi.org/10.3390/micro5020022

Vancouver

Kang J, Lee K, Choi Y, Kim S, Kim B. Process of Fabricating Hyaluronic Acid-Based Milli-to-Microneedles Using the Bi-Directional Drawing Method. Micro. 2025;5(2):22. doi:10.3390/micro5020022

BibTeX
@article{Kang2025,
  author = {Kang, Joon-Koo and Lee, Kihak and Choi, Yein and Kim, Se-Gie and Kim, Bonghwan},
  title = {Process of Fabricating Hyaluronic Acid-Based Milli-to-Microneedles Using the Bi-Directional Drawing Method},
  journal = {Micro},
  year = {2025},
  volume = {5},
  number = {2},
  pages = {22},
  doi = {10.3390/micro5020022}
}
Kostenlos starten →