EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Compact Analog Correlated Multiple Sampling with Ping-Pong Readout for Cooled Low-Noise Image Sensors

Mahir Sanli, Mehmet Ali Gulden, Enver Cavus

Micromachines · 09.11.2026 · 17 (11) · 1299

DOI: 10.3390/mi17111299 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Micromachines, online erschienen am 09.11.2026. Verfasst von Mahir Sanli und 2 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Conventional analog correlated multiple sampling (CMS) techniques become increasingly area-intensive when implemented in ping-pong column readout architectures because dedicated sampling capacitors are typically required for each interleaved readout path. This paper presents a compact analog ping-pong correlated multiple sampling (PP-CMS) architecture for cooled global-shutter image sensors that addresses this limitation by reusing storage capacitors across the two ping-pong paths. The proposed architecture enables 4-point CMS operation while requiring only two additional capacitors and three switches, without modifying the original ping-pong readout operation. The DDS-only column occupies approximately 550μm, and the additional PP-CMS circuitry increases the total column length by 50μm to approximately 600μm, corresponding to a 9.1% length overhead relative to the DDS-only implementation. A mathematical noise model is developed to analyze the thermal- and flicker-noise behavior of the proposed architecture and to clarify its trade-off relative to conventional switched-capacitor CMS. Since the proposed PP-CMS applies averaging directly to the double-delta sampling (DDS) output, it does not introduce the additional low-frequency attenuation associated with the reset–signal differencing operation of conventional SC-CMS; therefore, it is intended to improve the area–noise trade-off in ping-pong ROICs rather than to maximize intrinsic low-frequency flicker-noise suppression. A prototype readout integrated circuit (ROIC) fabricated in a 0.18-μm CMOS process was experimentally characterized at 80 K. The measured output noise was reduced from 93.5 μVrms for the DDS-only operation to 73.8 μVrms with 4-point PP-CMS, corresponding to a 21% reduction. These results demonstrate that the proposed PP-CMS architecture provides an effective trade-off between silicon area and readout-noise reduction for compact ping-pong ROIC implementations in cooled infrared imaging systems.

Zitieren

APA

Sanli, M., Gulden, M. A., & Cavus, E. (2026). Compact Analog Correlated Multiple Sampling with Ping-Pong Readout for Cooled Low-Noise Image Sensors. Micromachines, 17(11), 1299. https://doi.org/10.3390/mi17111299

Vancouver

Sanli M, Gulden MA, Cavus E. Compact Analog Correlated Multiple Sampling with Ping-Pong Readout for Cooled Low-Noise Image Sensors. Micromachines. 2026;17(11):1299. doi:10.3390/mi17111299

BibTeX
@article{Sanli2026,
  author = {Sanli, Mahir and Gulden, Mehmet Ali and Cavus, Enver},
  title = {Compact Analog Correlated Multiple Sampling with Ping-Pong Readout for Cooled Low-Noise Image Sensors},
  journal = {Micromachines},
  year = {2026},
  volume = {17},
  number = {11},
  pages = {1299},
  doi = {10.3390/mi17111299}
}
Kostenlos starten →