EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Effect of Tungsten Addition on the Hot Tearing Susceptibility of the AlSi5Cu2Mg Alloy

Marek Matejka, Dana Bolibruchová, Martina Sýkorová

Metals · 09.11.2026 · 16 (11) · 1225

DOI: 10.3390/met16111225 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 09.11.2026. Verfasst von Marek Matejka und 2 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Cultural and Educational Grant Agency (KEGA) of the Ministry of Education, Research, Development and Youth of the Slovak Republic.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hot tears are among the most serious casting defects and limit the applicability of Al-Si-Cu-Mg alloys in automotive castings. This work deals with the effect of a graded tungsten addition on the hot tearing susceptibility of the hypoeutectic AlSi5Cu2Mg alloy. Tungsten was introduced through an AlW5 master alloy in nominal additions of 0.05, 0.10 and 0.15 wt.%, corresponding to measured contents of 0.020, 0.044 and 0.075 wt.%. The susceptibility was evaluated using a five-arm restrained casting mould equipped with a load cell and a thermocouple, by three variants of the hot tearing index and by a qualitative evaluation of the load curve and its first derivative. The nominal 0.05 wt.% addition decreased all three indices into the minimal-to-low susceptibility category, whereas higher additions led to a renewed rise, and at 0.15 wt.% the values reached the level of the reference alloy. The qualitative evaluation confirmed this trend. Thermal analysis showed an increase in the liquidus temperature from 615 to 629 °C and a corresponding widening of the solidification interval. The favourable effect of the low addition is attributed to a possible grain refinement of the primary phase, whereas at higher contents the widened solidification interval prevails.

Förderung

  • Cultural and Educational Grant Agency (KEGA) of the Ministry of Education, Research, Development and Youth of the Slovak Republic

Zitieren

APA

Matejka, M., Bolibruchová, D., & Sýkorová, M. (2026). The Effect of Tungsten Addition on the Hot Tearing Susceptibility of the AlSi5Cu2Mg Alloy. Metals, 16(11), 1225. https://doi.org/10.3390/met16111225

Vancouver

Matejka M, Bolibruchová D, Sýkorová M. The Effect of Tungsten Addition on the Hot Tearing Susceptibility of the AlSi5Cu2Mg Alloy. Metals. 2026;16(11):1225. doi:10.3390/met16111225

BibTeX
@article{Matejka2026,
  author = {Matejka, Marek and Bolibruchová, Dana and Sýkorová, Martina},
  title = {The Effect of Tungsten Addition on the Hot Tearing Susceptibility of the AlSi5Cu2Mg Alloy},
  journal = {Metals},
  year = {2026},
  volume = {16},
  number = {11},
  pages = {1225},
  doi = {10.3390/met16111225}
}
Kostenlos starten →