Fatigue Behavior of Hybrid Additive/Subtractive Manufactured Ti-6Al-4V
Metals · 18.06.2026 · 16 (6) · 673
DOI: 10.3390/met16060673 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 18.06.2026. Verfasst von Nicholas Parolini und 5 weiteren Autor:innen. Die Arbeit nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Additive–subtractive hybrid manufacturing (ASHM) allows for the rapid manufacturing of metal components with complex and precise geometries for ready-to-use or near-ready-to-use applications. Laser wire-directed energy deposition (LW-DED) can be used to quickly manufacture metal components, while CNC machining can achieve precise geometric tolerances. In this study, Ti-6Al-4V alloy specimens were fabricated using an LW-DED process combined with CNC machining and tested to evaluate the effects of ASHM on mechanical performance. Post fabrication, the Ti-6Al-4V material was evaluated through hardness mapping, monotonic tensile testing, and fully reversed axial fatigue testing. Vicker’s micro-hardness mapping showed a range of hardness results from 300 to 350 HV in the ASHM Ti-6Al-4V that remained consistent throughout the build. Tensile results showed a similar response to cast and wrought Ti-6Al-4V, with an average yield stress of 819.4 MPa, ultimate tensile strength of 935.5 MPa, and modulus of 119 GPa. When tested in fatigue, the material had a reduced life compared to wrought Ti-6Al-4V, which is attributed to defects originating from the additive process. While no run-outs were observed from the testing, the fatigue results remain aligned with trends reported for other methods of additively manufactured Ti-6Al-4V. Fully reversed high-cycle fatigue loading revealed that the ASHM-fabricated Ti-6Al-4V fell into a Basquin power-law fit with a fatigue strength coefficient of 1942 MPa with a fatigue strength exponent of −0.115. The fatigue life of the ASHM material is found to be dependent on the resulting porosity of the material that stems from the LW-DED process used in the ASHM process described.
Zitieren
APA
Parolini, N., Ikeler, A., Kinser, R., Singh, A., Allison, P. G., & Jordon, J. B. (2026). Fatigue Behavior of Hybrid Additive/Subtractive Manufactured Ti-6Al-4V. Metals, 16(6), 673. https://doi.org/10.3390/met16060673
Vancouver
Parolini N, Ikeler A, Kinser R, Singh A, Allison PG, Jordon JB. Fatigue Behavior of Hybrid Additive/Subtractive Manufactured Ti-6Al-4V. Metals. 2026;16(6):673. doi:10.3390/met16060673
BibTeX
@article{Parolini2026,
author = {Parolini, Nicholas and Ikeler, Andrew and Kinser, Ryan and Singh, Abhendra and Allison, P. G. and Jordon, J. B.},
title = {Fatigue Behavior of Hybrid Additive/Subtractive Manufactured Ti-6Al-4V},
journal = {Metals},
year = {2026},
volume = {16},
number = {6},
pages = {673},
doi = {10.3390/met16060673}
}
EUVIMED