Study on the Mechanical Properties of Composite Special-Shaped Columns with RAC-Filled Square Steel Tubes
Metals · 09.05.2026 · 16 (5) · 515
DOI: 10.3390/met16050515 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 09.05.2026. Verfasst von Tengfei Ma und 3 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Research Project on Construction Science and Technology of the Department of Housing and Urban-Rural Development of Hebei Province.
Abstract (Originalsprache)
The L-shaped columns of recycled aggregate concrete-filled steel tubes (L-RACFSTs) with a 40% coarse aggregate replacement ratio were selected as the research subject, and axial compression and eccentric compression tests were conducted. Based on validated finite element numerical simulation methods, a parametric analysis was carried out, incorporating key parameters such as steel strength, width-to-thickness ratios of the square steel tube and connecting plate, and load eccentricity. The mechanical properties of L-RACFSTs under axial compression and eccentric compression loads were studied. The results show the following: (1) At a 40% replacement rate, axial compression specimens exhibited obvious in-plane deformation of the column limbs, whereas eccentric compression specimens showed overall bending toward the inner side of the column. (2) As the strength of the steel increases, the axial and eccentric compressive bearing capacities of the specimens gradually increase. It is recommended that structural steel with a strength grade of Q355 is adopted. (3) When the width of a square steel tube is fixed, the axial and eccentric compressive bearing capacities of the test specimen gradually increase as the width-to-thickness ratio decreases. (4) In contrast, for a connecting plate of a fixed width, an increase in the width-to-thickness ratio results in a decrease in bearing capacity. Additionally, due to the increased width of the connecting plate, bearing capacity will decrease in some cases. (5) The bearing capacity under eccentric loading decreases gradually as the eccentricity increases; it is recommended that the eccentricity be kept below 120 mm.
Förderung
- Research Project on Construction Science and Technology of the Department of Housing and Urban-Rural Development of Hebei Province
Zitieren
APA
Ma, T., Gao, X., Ma, Z., & Hao, Z. (2026). Study on the Mechanical Properties of Composite Special-Shaped Columns with RAC-Filled Square Steel Tubes. Metals, 16(5), 515. https://doi.org/10.3390/met16050515
Vancouver
Ma T, Gao X, Ma Z, Hao Z. Study on the Mechanical Properties of Composite Special-Shaped Columns with RAC-Filled Square Steel Tubes. Metals. 2026;16(5):515. doi:10.3390/met16050515
BibTeX
@article{Ma2026,
author = {Ma, Tengfei and Gao, Xuanran and Ma, Zhifeng and Hao, Ziqi},
title = {Study on the Mechanical Properties of Composite Special-Shaped Columns with RAC-Filled Square Steel Tubes},
journal = {Metals},
year = {2026},
volume = {16},
number = {5},
pages = {515},
doi = {10.3390/met16050515}
}
EUVIMED