Mechanical and Damping Characteristics of Mn–Cu Damping Alloy Due to Varying Aging Temperature
Metals · 29.04.2026 · 16 (5) · 480
DOI: 10.3390/met16050480 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 29.04.2026. Verfasst von Bin Wu und 8 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Central Iron and Steel Research Institute R&D special fund.
Abstract (Originalsprache)
This study investigated the relationship between Mn segregation, damping capacity, and mechanical properties of a Mn–Cu damping alloy after aging at different temperatures. The results showed that after aging, the alloy underwent spinodal decomposition, forming Mn-segregated regions, while α-Mn precipitates appeared at the grain boundaries. The microstructure resulting from spinodal decomposition promoted martensitic transformation, created twin boundaries, and enhanced damping capacity. As the aging temperature increased, the Mn content in the Mn-rich regions gradually rose, thereby raising the martensitic transformation temperature. The twin density first increased and then decreased, which may be attributed to the precipitation and broadening of the α-Mn phase along the grain boundaries of the Mn-rich regions when the aging temperature was too high. At an aging temperature of 425 °C, the tanδ reaches a maximum of 0.05, and the martensitic transformation temperature reaches 100 °C, at which point the tanδ remains 0.04. After aging at 425 °C, a preferred orientation along develops. The [001] orientation has the largest Schmid factor, which is most favorable for the reversible motion of twin boundaries under external stress, thus achieving the highest energy dissipation. To summarize, by promoting the creation of fine {011} twins by means of spinodal decomposition and by increasing the [001] oriented grain fraction through texture development, aging enhances the damping properties of the Mn–Cu alloy. In particular, the aging at 425 °C can provide the best combination of the microstructure and texture conditions, providing the highest damping performance in a wide temperature range.
Förderung
- Central Iron and Steel Research Institute R&D special fund
Zitieren
APA
Wu, B., Wu, Z., Li, B., Lu, F., Li, R., Zhang, X., Zhao, X., Zhao, F., & Zhao, D. (2026). Mechanical and Damping Characteristics of Mn–Cu Damping Alloy Due to Varying Aging Temperature. Metals, 16(5), 480. https://doi.org/10.3390/met16050480
Vancouver
Wu B, Wu Z, Li B, Lu F, Li R, Zhang X, et al. Mechanical and Damping Characteristics of Mn–Cu Damping Alloy Due to Varying Aging Temperature. Metals. 2026;16(5):480. doi:10.3390/met16050480
BibTeX
@article{Wu2026,
author = {Wu, Bin and Wu, Zhaobo and Li, Bibo and Lu, Fengshuang and Li, Ran and Zhang, Xiaojun and Zhao, Xinqing and Zhao, Feiyu and Zhao, Dongliang},
title = {Mechanical and Damping Characteristics of Mn–Cu Damping Alloy Due to Varying Aging Temperature},
journal = {Metals},
year = {2026},
volume = {16},
number = {5},
pages = {480},
doi = {10.3390/met16050480}
}
EUVIMED