Knowledge Transfer Between Machines in Laser Powder Bed Fusion—Transfer Learning with Small Training Datasets
Metals · 17.04.2026 · 16 (4) · 438
DOI: 10.3390/met16040438 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 17.04.2026. Verfasst von Florian Funcke und 3 weiteren Autor:innen. Die Arbeit nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Federal Ministry for Economic Affairs and Energy.
Abstract (Originalsprache)
Laser Powder Bed Fusion (PBF-LB) is currently one of the most versatile and adopted additive manufacturing technologies for printing metals. To take new PBF-LB machines into service, a thorough characterization and calibration is often necessary to get the desired output. This is commonly achieved empirically; however, data-driven methods have become more and more available over the last few years. This research explores the use of transfer learning (TL) to transfer process knowledge from an already-established source machine (Nikon SLM 500) to a target machine (Trumpf TruPrint 5000) with different hardware specifications. To predict the tensile properties of AlSi10Mg0.5 utilizing a minimal data set of merely 25 training samples, eight TL model variants, determined by their degrees of training freedom, were investigated. The results showed that TL is effective in transferring machine learning (ML)-based process models. High prediction accuracy was achieved on the target machine, with coefficient of determination (R2) values reaching 75.5% for yield strength, 82.1% for ultimate tensile strength, and up to 92.0% for elongation at break in testing. Additionally, a weighted mean model ensemble of all eight single models was developed, including all eight TL variants, to enable higher prediction robustness. Validation trials for three different use cases confirmed the capability of the approach to optimize processing conditions, like increasing hatch scan speed by 167% to 292% while maintaining high mechanical performance. Additional microstructure analysis was given to support the findings. The results demonstrate a time- and resource-efficient approach for rapid industrialization of PBF-LB machines, combining ML-based process modeling with machine-specific data.
Förderung
- Federal Ministry for Economic Affairs and Energy
Zitieren
APA
Funcke, F., Brummer, S., Kolbinger, M., & Mayr, P. (2026). Knowledge Transfer Between Machines in Laser Powder Bed Fusion—Transfer Learning with Small Training Datasets. Metals, 16(4), 438. https://doi.org/10.3390/met16040438
Vancouver
Funcke F, Brummer S, Kolbinger M, Mayr P. Knowledge Transfer Between Machines in Laser Powder Bed Fusion—Transfer Learning with Small Training Datasets. Metals. 2026;16(4):438. doi:10.3390/met16040438
BibTeX
@article{Funcke2026,
author = {Funcke, Florian and Brummer, Sebastian and Kolbinger, Marinus and Mayr, Peter},
title = {Knowledge Transfer Between Machines in Laser Powder Bed Fusion—Transfer Learning with Small Training Datasets},
journal = {Metals},
year = {2026},
volume = {16},
number = {4},
pages = {438},
doi = {10.3390/met16040438}
}
EUVIMED