EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Effect of the Forming Mode on Twinning and Springback in the Bending-Dominated Forming of Magnesium AZ31 Sheet

Matthias Weiss, Shiromani Gangoda Desinghe, Peter Hodgson, Hossein Beladi

Metals · 29.08.2024 · 14 (9) · 983

DOI: 10.3390/met14090983 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 29.08.2024. Verfasst von Matthias Weiss und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Australian Research Council (ARC).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The sheet metal forming of magnesium is challenging due to the material’s complex springback behaviour, which is due to the tension/compression yield mismatch. In this study, three different AZ31 grain sizes are produced by a special heat treatment, while maintaining the material strength in uniaxial tension at a similar level. Pure, V-die and channel bending tests are combined with roll forming to compare bending scenarios with and without tension applied transverse and parallel to the bending axis. This is complemented with electron backscatter diffraction to measure the twinning type and twinning area fraction (TAF) in the tension and compression bending zones. Our study shows that, like conventional steel, when bending magnesium, springback reduces with the increasing level of the outer fibre bending strain, i.e., when the bend radius is decreased and the TAF increased. It is further shown that when tension is applied, the TAF increases. However, while in some forming cases, the increase in TAF leads to a clear reduction in springback, in other forming cases the effect of the TAF on springback is less pronounced. Overall, this study provides clear evidence that the twinning behaviour in bending magnesium is influenced by the bend deformation mode and that this influences the springback behaviour.

Förderung

  • Australian Research Council (ARC)

Zitieren

APA

Weiss, M., Desinghe, S. G., Hodgson, P., & Beladi, H. (2024). The Effect of the Forming Mode on Twinning and Springback in the Bending-Dominated Forming of Magnesium AZ31 Sheet. Metals, 14(9), 983. https://doi.org/10.3390/met14090983

Vancouver

Weiss M, Desinghe SG, Hodgson P, Beladi H. The Effect of the Forming Mode on Twinning and Springback in the Bending-Dominated Forming of Magnesium AZ31 Sheet. Metals. 2024;14(9):983. doi:10.3390/met14090983

BibTeX
@article{Weiss2024,
  author = {Weiss, Matthias and Desinghe, Shiromani Gangoda and Hodgson, Peter and Beladi, Hossein},
  title = {The Effect of the Forming Mode on Twinning and Springback in the Bending-Dominated Forming of Magnesium AZ31 Sheet},
  journal = {Metals},
  year = {2024},
  volume = {14},
  number = {9},
  pages = {983},
  doi = {10.3390/met14090983}
}
Kostenlos starten →