EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Effects of Strain Rate and Anisotropy on the Formability and Mechanical Behaviour of Aluminium Alloy 2024-T3

Martin Harant, Patricia Verleysen, Milan Forejt, Stepan Kolomy

Metals · 13.01.2024 · 14 (1) · 98

DOI: 10.3390/met14010098 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 13.01.2024. Verfasst von Martin Harant und 3 weiteren Autor:innen. Die Arbeit wurde bisher 26-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Faculty of Mechanical Engineering, Brno University of Technology.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The present study focuses on the mechanical behaviour and formability of the aluminium alloy 2024-T3 in sheet form with a thickness of 0.8 mm. For this purpose, tensile tests at quasi-static and intermediate strain rates were performed using a universal testing machine, and high strain rate experiments were performed using a split Hopkinson tension bar (SHTB) facility. The material’s anisotropy was investigated by considering seven different specimen orientations relative to the rolling direction. Digital image correlation (DIC) was used to measure specimen deformation. Based on the true stress–strain curves, the alloy exhibited negative strain rate sensitivity (NSRS). Dynamic strain aging (DSA) was investigated as a possible cause. However, neither the strain distribution nor the stress–strain curves gave further indications of the occurrence of DSA. A higher deformation capacity was observed in the high strain rate experiments. The alloy displayed anisotropic mechanical properties. Values of the Lankford coefficient lower than 1, more specifically, varying between 0.45 and 0.87 depending on specimen orientations and strain rate, were found. The hardening exponent was not significantly dependent on specimen orientation and only moderately affected by strain rate. An average value of 0.183 was observed for specimens tested at a quasi-static strain rate. Scanning electron microscopy (SEM) revealed a typical ductile fracture morphology with fine dimples. Dimple sizes were hardly affected by specimen orientation and strain rate.

Förderung

  • Faculty of Mechanical Engineering, Brno University of Technology

Zitieren

APA

Harant, M., Verleysen, P., Forejt, M., & Kolomy, S. (2024). The Effects of Strain Rate and Anisotropy on the Formability and Mechanical Behaviour of Aluminium Alloy 2024-T3. Metals, 14(1), 98. https://doi.org/10.3390/met14010098

Vancouver

Harant M, Verleysen P, Forejt M, Kolomy S. The Effects of Strain Rate and Anisotropy on the Formability and Mechanical Behaviour of Aluminium Alloy 2024-T3. Metals. 2024;14(1):98. doi:10.3390/met14010098

BibTeX
@article{Harant2024,
  author = {Harant, Martin and Verleysen, Patricia and Forejt, Milan and Kolomy, Stepan},
  title = {The Effects of Strain Rate and Anisotropy on the Formability and Mechanical Behaviour of Aluminium Alloy 2024-T3},
  journal = {Metals},
  year = {2024},
  volume = {14},
  number = {1},
  pages = {98},
  doi = {10.3390/met14010098}
}
Kostenlos starten →