EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Functionally Graded Additive Manufacturing of Thin-Walled 316L Stainless Steel-Inconel 625 by Direct Laser Metal Deposition Process: Characterization and Evaluation

Omid Mehrabi, Seyed Mohammad Hossein Seyedkashi, Mahmoud Moradi

Metals · 12.06.2023 · 13 (6) · 1108

DOI: 10.3390/met13061108 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 12.06.2023. Verfasst von Omid Mehrabi und 2 weiteren Autor:innen. Die Arbeit wurde bisher 48-mal zitiert (Crossref) und nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Direct Laser Metal Deposition (DLMD) is a state-of-the-art manufacturing technology used to fabricate 316L stainless steel/Inconel 625 functionally graded material (FGMs) in this research. For the practical application of these materials in the industry, the effects of process parameters on the geometric characteristics and surface roughness require more investigation. This FGM was additively manufactured in five layers by changing the 316L stainless steel/Inconel 625 ratio in each layer. The effects of laser power on geometric characteristics, height stability, and surface roughness were investigated. The microstructural analysis and microhardness profiles were studied. The results show that despite the high solidification rate, the segregation of alloying elements into dendritic areas occurred. It was also found that increasing the laser power will increase the height, width, height stability, and surface roughness of the gradient walls. The maximum width and height of the deposited layers were 1.615 and 6.42 mm, respectively, at the highest laser power (280 W). At the laser power of 220 W, the least surface roughness (Ra = 105 µm) and the best height stability (0.461 mm) will be obtained. The microhardness values will differ in various sections of the gradient walls in a range of 225–277 HV.

Zitieren

APA

Mehrabi, O., Seyedkashi, S. M. H., & Moradi, M. (2023). Functionally Graded Additive Manufacturing of Thin-Walled 316L Stainless Steel-Inconel 625 by Direct Laser Metal Deposition Process: Characterization and Evaluation. Metals, 13(6), 1108. https://doi.org/10.3390/met13061108

Vancouver

Mehrabi O, Seyedkashi SMH, Moradi M. Functionally Graded Additive Manufacturing of Thin-Walled 316L Stainless Steel-Inconel 625 by Direct Laser Metal Deposition Process: Characterization and Evaluation. Metals. 2023;13(6):1108. doi:10.3390/met13061108

BibTeX
@article{Mehrabi2023,
  author = {Mehrabi, Omid and Seyedkashi, Seyed Mohammad Hossein and Moradi, Mahmoud},
  title = {Functionally Graded Additive Manufacturing of Thin-Walled 316L Stainless Steel-Inconel 625 by Direct Laser Metal Deposition Process: Characterization and Evaluation},
  journal = {Metals},
  year = {2023},
  volume = {13},
  number = {6},
  pages = {1108},
  doi = {10.3390/met13061108}
}
Kostenlos starten →