EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Porous SiC Ceramic Membranes Prepared by Low-Temperature Sintering: Filtration Performance in Mine Water Treatment and Alkaline Cleaning Stability

Yuhang Jin, Xufeng Xu, Binbin Du, Haibo Du, Yameng Li, Sai Ma

Membranes · 29.10.2026 · 16 (11) · 367

DOI: 10.3390/membranes16110367 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Membranes, online erschienen am 29.10.2026. Verfasst von Yuhang Jin und 5 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: China Coal Technology and Engineering Group.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Low-temperature fabrication of porous silicon carbide (SiC) ceramic membranes using secondary bonding phases offers an alternative to conventional high-temperature sintering. This study compared aluminium-sol- and silica-sol-derived SiC membranes fabricated in air at 1300 °C with sol additions of 10–40 wt.%, focusing on pore structure, mechanical strength, mine-water filtration, fouling behaviour, and alkaline oxidative cleaning. X-ray diffraction revealed weak features potentially associated with mullite formation in the aluminium-sol membranes, while SiO2-related phases were observed in the silica-sol membranes. Increasing sol content reduced porosity, pore diameter, and permeate flux while improving flexural strength. SiC-30%Al-sol provided a favourable performance balance, achieving a flexural strength of 25.2 MPa, a permeate flux of approximately 230 L m−2 h−1 after 40 min of mine-water filtration, and a final permeate turbidity of approximately 0.3 NTU. For SiC-30%Al-sol, the cake-filtration model provided the best fit over the 5–20 min interval, without establishing the dominant fouling mechanism. Following a single NaOH/NaClO cleaning cycle, SiC-30%Al-sol exhibited 90.4% flux recovery and 15.1% flexural-strength loss. Aluminium-sol membranes generally showed smaller strength losses and surface-roughness changes than silica-sol membranes under the tested conditions. These findings highlight the influence of bonding-phase chemistry on membrane performance, although repeated cleaning and post-cleaning pore-structure measurements are needed to establish long-term durability.

Förderung

  • China Coal Technology and Engineering Group

Zitieren

APA

Jin, Y., Xu, X., Du, B., Du, H., Li, Y., & Ma, S. (2026). Porous SiC Ceramic Membranes Prepared by Low-Temperature Sintering: Filtration Performance in Mine Water Treatment and Alkaline Cleaning Stability. Membranes, 16(11), 367. https://doi.org/10.3390/membranes16110367

Vancouver

Jin Y, Xu X, Du B, Du H, Li Y, Ma S. Porous SiC Ceramic Membranes Prepared by Low-Temperature Sintering: Filtration Performance in Mine Water Treatment and Alkaline Cleaning Stability. Membranes. 2026;16(11):367. doi:10.3390/membranes16110367

BibTeX
@article{Jin2026,
  author = {Jin, Yuhang and Xu, Xufeng and Du, Binbin and Du, Haibo and Li, Yameng and Ma, Sai},
  title = {Porous SiC Ceramic Membranes Prepared by Low-Temperature Sintering: Filtration Performance in Mine Water Treatment and Alkaline Cleaning Stability},
  journal = {Membranes},
  year = {2026},
  volume = {16},
  number = {11},
  pages = {367},
  doi = {10.3390/membranes16110367}
}
Kostenlos starten →