EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Ceramic TiO2 Membrane Modification by Coal Fly Ash (CFA) Particles

Saidulla Faizullayev, Akbota Adilbekova, Joanna Kujawa, Wojciech Kujawski iD

Membranes · 29.04.2026 · 16 (5) · 157

DOI: 10.3390/membranes16050157 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Membranes, online erschienen am 29.04.2026. Verfasst von Saidulla Faizullayev und 3 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, Almaty 050040, Kazakhstan. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: The Science Committee of the Ministry of Science and Higher Education of the Republic of Ka-zakhstan, Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan, PROM scholarship program by Polish National Agency for Academic Exchange.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Commercial TiO2 ceramic membranes were modified using a slip-casting method with coal fly ash (CFA) obtained from a thermal power plant, Almaty, Kazakhstan. The aim was to enhance membrane surface properties for improved oil-in-water emulsion separation while maintaining structural integrity. Suspension of CFA, stabilized with N-dodecylpyridinium chloride (DPC) and polyvinyl alcohol (PVA), was applied as a coating layer on the TiO2 surface and subsequently sintered under controlled conditions. The resulting membranes were characterized by SEM-EDX (scanning electron microscopy with energy-dispersive X-ray), Raman spectroscopy, contact angle measurements, and zeta potential analysis. The modified membranes exhibited increased hydrophilicity, as indicated by a reduction in water contact angle (WCA) from 43.6 ± 2° to approximately 0°, and a decrease in the underoil contact angle of water (UOCA) from 147.6 ± 2° to 87 ± 2°. Raman spectroscopy confirmed that the TiO2 structure remained predominantly rutile, with no additional crystalline phases detected from CFA. Despite the improved wettability, pure water and oil-in-water emulsion fluxes decreased slightly, while filtrates displayed smaller oil droplet sizes, indicating enhanced emulsion stability after passage through the modified surface. These findings demonstrate that CFA-modified TiO2 membranes can serve as a sustainable and cost-effective approach for treating emulsified wastewater, utilizing industrial waste to improve performance without compromising mechanical robustness.

Schlagwörter

Stichwörter der Autor:innen

coal fly ashmembrane modificationmembrane separationoil-in-water emulsiontitania membrane

Autor:innen und Institutionen

  • Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, Almaty 050040, Kazakhstan.
  • Faculty of Chemistry, Nicolaus Copernicus University in Torun, 87-100 Torun, Poland.

ORCID-Profile: Wojciech Kujawski

Förderung

  • The Science Committee of the Ministry of Science and Higher Education of the Republic of Ka-zakhstan
  • Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan
  • PROM scholarship program by Polish National Agency for Academic Exchange

Zitieren

APA

Faizullayev, S., Adilbekova, A., Kujawa, J., & Kujawski, W. (2026). Ceramic TiO2 Membrane Modification by Coal Fly Ash (CFA) Particles. Membranes, 16(5), 157. https://doi.org/10.3390/membranes16050157

Vancouver

Faizullayev S, Adilbekova A, Kujawa J, Kujawski W. Ceramic TiO2 Membrane Modification by Coal Fly Ash (CFA) Particles. Membranes. 2026;16(5):157. doi:10.3390/membranes16050157

BibTeX
@article{Faizullayev2026,
  author = {Faizullayev, Saidulla and Adilbekova, Akbota and Kujawa, Joanna and Kujawski, Wojciech},
  title = {Ceramic TiO2 Membrane Modification by Coal Fly Ash (CFA) Particles},
  journal = {Membranes},
  year = {2026},
  volume = {16},
  number = {5},
  pages = {157},
  doi = {10.3390/membranes16050157}
}
Kostenlos starten →