Third-Order Peak Localization of Tool-Axis Orientation Error for NC Densification in A–C Five-Axis Machining
Machines · 30.10.2026 · 14 (11) · 1263
DOI: 10.3390/machines14111263 ↗Kurz gefasst
Fachartikel in der Zeitschrift Machines, online erschienen am 30.10.2026. Verfasst von Zehong Lu und 3 weiteren Autor:innen. Die Arbeit nennt 25 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Beijing Natural Science Foundation, National Key Research and Development Program of China.
Abstract (Originalsprache)
Linear rotary-axis interpolation in five-axis machining can induce nonlinear tool-axis orientation error despite rotation-tool-center-point compensation of the tool-tip position. This study analyzes this effect for well-conditioned blocks of an A–C rotary-table configuration using the signed out-of-plane deviation from the endpoint geodesic plane on the unit sphere S2. A local asymptotic analysis explains the symmetric second-order midpoint approximation and derives the leading third-order shift of the local error peak. A peak-guided uniform (PGU) method for densifying numerical control (NC) blocks is then developed. The third-order model selects a probing location, at which the exact nonlinear error is evaluated; local quadratic scaling then directly estimates the subdivision number. The reference-path-reconstructed sequence is assessed by independent dense sampling. For the largest representative block, the peak-location discrepancy decreases from 0.072 with the midpoint assumption to 0.023 with the third-order predictor. In the coarsest tested blade-path case (r=4), PGU matches the inserted-point count of dense-search uniform subdivision and uses 27.2% fewer inserted points than the midpoint and peak-corrected refinement baselines. Across the tested tolerances, PGU satisfies the same dense-validation criterion as the reference methods with comparable final block counts. At r=4, its median runtime is approximately 94.6% lower than that of dense-search uniform subdivision.
Förderung
- Beijing Natural Science Foundation
- National Key Research and Development Program of China
Zitieren
APA
Lu, Z., Zhang, Q., Huo, G., & Jiang, X. (2026). Third-Order Peak Localization of Tool-Axis Orientation Error for NC Densification in A–C Five-Axis Machining. Machines, 14(11), 1263. https://doi.org/10.3390/machines14111263
Vancouver
Lu Z, Zhang Q, Huo G, Jiang X. Third-Order Peak Localization of Tool-Axis Orientation Error for NC Densification in A–C Five-Axis Machining. Machines. 2026;14(11):1263. doi:10.3390/machines14111263
BibTeX
@article{Lu2026,
author = {Lu, Zehong and Zhang, Qisheng and Huo, Guanying and Jiang, Xin},
title = {Third-Order Peak Localization of Tool-Axis Orientation Error for NC Densification in A–C Five-Axis Machining},
journal = {Machines},
year = {2026},
volume = {14},
number = {11},
pages = {1263},
doi = {10.3390/machines14111263}
}
EUVIMED