Hydrogen Injection Pressure as a Control Parameter for Combustion, Efficiency, and Emissions in a Spark-Ignition Engine
Machines · 07.06.2026 · 14 (6) · 661
DOI: 10.3390/machines14060661 ↗Kurz gefasst
Fachartikel in der Zeitschrift Machines, online erschienen am 07.06.2026. Verfasst von Saugirdas Pukalskas und 6 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Economic Revitalization and Resilience Enhancement Plan “New Generation Lithuania”.
Abstract (Originalsprache)
This study investigates the effect of hydrogen injection pressure on combustion, energy, and emission characteristics of a spark-ignition engine under stoichiometric operating conditions. Experiments were performed on a four-cylinder Nissan HR16DE engine at 2500 rpm and 0.48 MPa brake mean effective pressure using gasoline and hydrogen-enriched blends containing 10%, 20%, and 30% hydrogen by mass. Hydrogen was injected into the intake manifold at pressures of 1.2, 1.4, 1.6, and 1.9 bar, while spark timing was adjusted to maintain peak in-cylinder pressure at 14–15 CAD after top dead center. Results showed that hydrogen mass fraction had a much stronger influence on engine performance than injection pressure. Increasing hydrogen content intensified combustion, shortened ignition delay, increased heat release rate and in-cylinder temperature, and reduced brake-specific fuel consumption by up to 36% compared with pure gasoline. Hydrogen enrichment also reduced HC and CO2 emissions, but increased NOx emissions. Effect of injection pressure was secondary and depended on hydrogen concentration. Under the investigated conditions, the lowest tested pressure, 1.2 bar, was generally the most favorable, especially at lower hydrogen fractions. Overall, hydrogen injection pressure acted mainly as a mixture formation control parameter, while hydrogen mass fraction remained the dominant factor determining engine behavior.
Förderung
- Economic Revitalization and Resilience Enhancement Plan “New Generation Lithuania”
Zitieren
APA
Pukalskas, S., Rimkus, A., Mejeras, G., Kriaučiūnas, D., Stravinskas, S., Vipartas, T., & Ušinskas, A. (2026). Hydrogen Injection Pressure as a Control Parameter for Combustion, Efficiency, and Emissions in a Spark-Ignition Engine. Machines, 14(6), 661. https://doi.org/10.3390/machines14060661
Vancouver
Pukalskas S, Rimkus A, Mejeras G, Kriaučiūnas D, Stravinskas S, Vipartas T, et al. Hydrogen Injection Pressure as a Control Parameter for Combustion, Efficiency, and Emissions in a Spark-Ignition Engine. Machines. 2026;14(6):661. doi:10.3390/machines14060661
BibTeX
@article{Pukalskas2026,
author = {Pukalskas, Saugirdas and Rimkus, Alfredas and Mejeras, Gabrielius and Kriaučiūnas, Donatas and Stravinskas, Saulius and Vipartas, Tadas and Ušinskas, Andrius},
title = {Hydrogen Injection Pressure as a Control Parameter for Combustion, Efficiency, and Emissions in a Spark-Ignition Engine},
journal = {Machines},
year = {2026},
volume = {14},
number = {6},
pages = {661},
doi = {10.3390/machines14060661}
}
EUVIMED