EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Corner Smoothing with Feedrate Interpolation for High-Speed Machine Tools

Haowen Xue, Xiaoyong Li, Shijing Wu, Liang Liang

Machines · 28.05.2026 · 14 (6) · 608

DOI: 10.3390/machines14060608 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Machines, online erschienen am 28.05.2026. Verfasst von Haowen Xue und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In high-speed machining, linear toolpaths constructed from a series of short line segments are widely used but inevitably introduce tangent and curvature discontinuities at segment junctions, which may cause feedrate fluctuation and contouring error. To address this problem, this study proposes a real-time corner smoothing and feedrate interpolation method based on dual cubic Bézier transition curves and an optimal error assignment model. The main contribution lies in coupling analytical corner rounding with error allocation: the approximation error and maximum curvature of the transition curves are obtained explicitly, while the allowable tolerance is optimally distributed between approximation error and chord error so that the overall trajectory error remains within the prescribed bound. A jerk-limited look-ahead interpolator is then developed through reverse scanning and forward interpolation to satisfy geometric constraints, drive constraints, and feedrate commands. Simulation results for a three-dimensional toolpath show that the approximation error, chord error, and total trajectory error are all constrained within the preset tolerance of 0.05 mm. In the mask-machining case, the proposed method reduces the machining time to 13.9 s, corresponding to reductions of approximately 70% and 25% compared with the method without look-ahead and the method with look-ahead only, respectively. These results indicate that the proposed framework can improve motion smoothness and machining efficiency while maintaining trajectory accuracy.

Zitieren

APA

Xue, H., Li, X., Wu, S., & Liang, L. (2026). Corner Smoothing with Feedrate Interpolation for High-Speed Machine Tools. Machines, 14(6), 608. https://doi.org/10.3390/machines14060608

Vancouver

Xue H, Li X, Wu S, Liang L. Corner Smoothing with Feedrate Interpolation for High-Speed Machine Tools. Machines. 2026;14(6):608. doi:10.3390/machines14060608

BibTeX
@article{Xue2026,
  author = {Xue, Haowen and Li, Xiaoyong and Wu, Shijing and Liang, Liang},
  title = {Corner Smoothing with Feedrate Interpolation for High-Speed Machine Tools},
  journal = {Machines},
  year = {2026},
  volume = {14},
  number = {6},
  pages = {608},
  doi = {10.3390/machines14060608}
}
Kostenlos starten →