EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Contact-Based Wear Modeling of Coated Deep Bores Manufactured by Electrochemical Rifling

Veselina Krasimirova Dimitrova, Ventsislav Panev Dimitrov, Galya Stoyanova Zdravcheva

Machines · 07.05.2026 · 14 (5) · 515

DOI: 10.3390/machines14050515 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Machines, online erschienen am 07.05.2026. Verfasst von Veselina Krasimirova Dimitrova und 2 weiteren Autor:innen. Die Arbeit nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study presents an analytical–experimental investigation of the mechanical and tribological behaviour of two coating systems applied to deep, internally profiled cylindrical components manufactured via Electrochemical Rifling (ECR): a hard anodised aluminium oxide (AAO) coating on an aluminium alloy and a hard chromium coating on alloy steel. Experimental characterisation includes microhardness measurements, coefficient of friction determination, and controlled sliding wear tests. The chromium coating exhibits approximately 2.5 times higher microhardness and about 15% lower average coefficient of friction compared to the anodised aluminium layer, resulting in significantly improved wear resistance. Acceptable engineering agreement is observed between analytical predictions and experimental results. For chromium-coated steel, analytical predictions yield approximately 67,200–72,600 cycles, while the experimentally estimated value is about 36,200 cycles. For anodised aluminium, analytical predictions range from approximately 1688 to 2803 cycles, compared to an experimental value of about 2012 cycles. A conservative reliability-oriented criterion yields service lives of approximately 12,000 cycles for chromium coatings and 1000 cycles for anodised aluminium. Weibull-based analysis (R = 0.95) indicates service life ranges of approximately 9300–10,000 and 230–390 cycles, respectively.

Zitieren

APA

Dimitrova, V. K., Dimitrov, V. P., & Zdravcheva, G. S. (2026). Contact-Based Wear Modeling of Coated Deep Bores Manufactured by Electrochemical Rifling. Machines, 14(5), 515. https://doi.org/10.3390/machines14050515

Vancouver

Dimitrova VK, Dimitrov VP, Zdravcheva GS. Contact-Based Wear Modeling of Coated Deep Bores Manufactured by Electrochemical Rifling. Machines. 2026;14(5):515. doi:10.3390/machines14050515

BibTeX
@article{Dimitrova2026,
  author = {Dimitrova, Veselina Krasimirova and Dimitrov, Ventsislav Panev and Zdravcheva, Galya Stoyanova},
  title = {Contact-Based Wear Modeling of Coated Deep Bores Manufactured by Electrochemical Rifling},
  journal = {Machines},
  year = {2026},
  volume = {14},
  number = {5},
  pages = {515},
  doi = {10.3390/machines14050515}
}
Kostenlos starten →