EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Optimization of the Surface Roughness and Chip Compression Ratio of Duplex Stainless Steel in a Wet Turning Process Using the Taguchi Method

Virginija Gyliene, Algimantas Brasas, Antanas Ciuplys, Janina Jablonskyte

Machines · 26.06.2024 · 12 (7) · 437

DOI: 10.3390/machines12070437 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Machines, online erschienen am 26.06.2024. Verfasst von Virginija Gyliene und 3 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: The department of Transport Engineering.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Duplex stainless steels (DSSs) are used in many applications due to their properties, such as high mechanical strength, good corrosion resistance, and relatively low cost. Nevertheless, DSS belongs to the materials group that is difficult to machine. The demand for a total increase in the production requires the optimization of cutting conditions. This paper examines the influence of cutting parameters, namely cutting velocity, feed, and the depth of cut on the surface roughness and chip compression ratio (CCR) after the DSS wet turning process. The study employed Taguchi optimization to determine the ideal cutting parameters for wet turning finishing operations on steel 1.4462. Using the Taguchi design, experiments focused on surface roughness (Ra) and CCR. Utilizing a TiAlN/TiN-PVD coating insert with a 0.4 mm nose radius, cutting velocity of 200 m/min, feed rates of 0.05 mm/rev, and cutting depths of 1 mm yielded the lowest Ra at 0.433 μm. Meanwhile, a cutting velocity of 200 m/min, feed rate of 0.15 mm/rev, and cutting depth of 0.5 mm resulted in the smallest CCR at 1.39, indicating minimal plastic deformation. The inclusion of additional cooling proved beneficial for surface roughness compared to dry and wet turning methods. The experimental data holds value for training and validating artificial intelligence models, preventing overfitting by ensuring sufficient data collection.

Förderung

  • The department of Transport Engineering

Zitieren

APA

Gyliene, V., Brasas, A., Ciuplys, A., & Jablonskyte, J. (2024). Optimization of the Surface Roughness and Chip Compression Ratio of Duplex Stainless Steel in a Wet Turning Process Using the Taguchi Method. Machines, 12(7), 437. https://doi.org/10.3390/machines12070437

Vancouver

Gyliene V, Brasas A, Ciuplys A, Jablonskyte J. Optimization of the Surface Roughness and Chip Compression Ratio of Duplex Stainless Steel in a Wet Turning Process Using the Taguchi Method. Machines. 2024;12(7):437. doi:10.3390/machines12070437

BibTeX
@article{Gyliene2024,
  author = {Gyliene, Virginija and Brasas, Algimantas and Ciuplys, Antanas and Jablonskyte, Janina},
  title = {Optimization of the Surface Roughness and Chip Compression Ratio of Duplex Stainless Steel in a Wet Turning Process Using the Taguchi Method},
  journal = {Machines},
  year = {2024},
  volume = {12},
  number = {7},
  pages = {437},
  doi = {10.3390/machines12070437}
}
Kostenlos starten →