Tool Wear State Identification Based on the IWOA-VMD Feature Selection Method
Machines · 12.03.2024 · 12 (3) · 184
DOI: 10.3390/machines12030184 ↗Kurz gefasst
Fachartikel in der Zeitschrift Machines, online erschienen am 12.03.2024. Verfasst von Xing Shui und 4 weiteren Autor:innen. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Key Research and Development Program of Hubei Province.
Abstract (Originalsprache)
Complex, thin-walled components are the most important load-bearing structures in aircraft equipment. Monitoring the wear status of milling cutters is critical for enhancing the precision and efficiency of thin-walled item machining. The cutting force signals of milling cutters are non-stationary and non-linear, making it difficult to detect wear stages. In response to this issue, a system for monitoring milling cutter wear has been presented, which is based on parameterized Variational Mode Decomposition (VMD) Multiscale Permutation Entropy. Initially, an updated whale optimization technique is used, with the joint correlation coefficient serving as the fitness value for determining the VMD parameters. The improved VMD technique is then used to break down the original signal into a series of intrinsic mode functions, and the Multiscale Permutation Entropy of each effective mode is determined to generate a feature vector. Finally, a 1D Convolutional Neural Network (1D CNN) is employed as the input model for state monitoring using the feature vector. The experimental findings show that the suggested technique can efficiently extract characteristics indicating the wear condition of milling cutters, allowing for the precise monitoring of milling cutter wear states. The recognition rate is as high as 98.4375%, which is superior to those of comparable approaches.
Förderung
- Key Research and Development Program of Hubei Province
Zitieren
APA
Shui, X., Rong, Z., Dan, B., He, Q., & Yang, X. (2024). Tool Wear State Identification Based on the IWOA-VMD Feature Selection Method. Machines, 12(3), 184. https://doi.org/10.3390/machines12030184
Vancouver
Shui X, Rong Z, Dan B, He Q, Yang X. Tool Wear State Identification Based on the IWOA-VMD Feature Selection Method. Machines. 2024;12(3):184. doi:10.3390/machines12030184
BibTeX
@article{Shui2024,
author = {Shui, Xing and Rong, Zhijun and Dan, Binbin and He, Qiangjian and Yang, Xin},
title = {Tool Wear State Identification Based on the IWOA-VMD Feature Selection Method},
journal = {Machines},
year = {2024},
volume = {12},
number = {3},
pages = {184},
doi = {10.3390/machines12030184}
}
EUVIMED