EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effects of Process Parameters on High-Speed Laser Cladded Inconel 625 Coatings on Q345 Steel: Molten Zone, Microstructure and Tensile Properties

Cheng Zhong, Guorong Lan, Yinghao Miao, Xuechong Ren

Materials · 15.11.2026 · 19 (22) · 4844

DOI: 10.3390/ma19224844 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 15.11.2026. Verfasst von Cheng Zhong und 3 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Compared with traditional laser cladding, high-speed laser cladding offers higher coating deposition efficiency and a smaller heat-affected zone. However, the causes of melt-pool asymmetry on the substrate surface and their effects on the substrate microstructure and mechanical properties remain unclear. This study focuses on Q345 steel and Inconel 625 powder, aiming to elucidate how process parameters influence melt pool behavior and how coating formation affects the substrate microstructure and mechanical properties. The results showed that melt-pool width and depth increased with increasing laser power but decreased with increasing laser scanning speed. Increasing the powder feed rate increased coating height and width while reducing the dimensions of the remelted region in the substrate. Melt-pool asymmetry arose from nonuniform powder flow and disturbed laser-powder interactions, whereas the lack of temporal synchronization among the three laser beams had a negligible effect on this asymmetry. In the multi-track coating, iron segregated mainly in the overlap regions between adjacent tracks and overlap higher than 65% promoted lack-of-fusion porosity. The coating exhibited coarse epitaxial columnar grains, a strong texture, and predominantly recrystallized or recovered structures with low lattice distortion. The Inconel 625 coating significantly enhanced the tensile strength of the Q345 substrate. Compared with uncoated Q345 steel, the coated specimens tested parallel and perpendicular to the laser-scanning direction exhibited increases in ultimate tensile strength of approximately 118 and 137 MPa, respectively.

Zitieren

APA

Zhong, C., Lan, G., Miao, Y., & Ren, X. (2026). Effects of Process Parameters on High-Speed Laser Cladded Inconel 625 Coatings on Q345 Steel: Molten Zone, Microstructure and Tensile Properties. Materials, 19(22), 4844. https://doi.org/10.3390/ma19224844

Vancouver

Zhong C, Lan G, Miao Y, Ren X. Effects of Process Parameters on High-Speed Laser Cladded Inconel 625 Coatings on Q345 Steel: Molten Zone, Microstructure and Tensile Properties. Materials. 2026;19(22):4844. doi:10.3390/ma19224844

BibTeX
@article{Zhong2026,
  author = {Zhong, Cheng and Lan, Guorong and Miao, Yinghao and Ren, Xuechong},
  title = {Effects of Process Parameters on High-Speed Laser Cladded Inconel 625 Coatings on Q345 Steel: Molten Zone, Microstructure and Tensile Properties},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {22},
  pages = {4844},
  doi = {10.3390/ma19224844}
}
Kostenlos starten →