Tribological and Mechanical Performance of 3D-Printed Polymers for Water-Lubricated Sliding Bearings
Materials · 24.08.2026 · 19 (17) · 3593
DOI: 10.3390/ma19173593 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 24.08.2026. Verfasst von Jolanta Krupa und 4 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Mechanical Engineering and Robotics, AGH University of Krakow, Al. A. Mickiewicza 30, 30-059 Krakow, Poland. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Centre for Research and Development.
Abstract (Originalsprache)
This paper presents the results of experimental studies on the mechanical and tribological properties of samples produced using the fused filament fabrication method. These studies aim to identify a potential material for a water-lubricated sliding bearing that will be manufactured using 3D printing. Printed specimens fabricated from four different materials were analyzed for surface profile, mechanical properties via the instrumented indentation method, and tribological behavior using a pin-on-disc setup. Although increased hardness is generally associated with improved resistance to wear, the material that exhibited the lowest wear in the pin-on-disc tests was characterized by the lowest hardness among all investigated materials. The findings suggest that other aspects, including wear mechanisms, wear products, and tribolayer development, may also exert a substantial influence.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Faculty of Mechanical Engineering and Robotics, AGH University of Krakow, Al. A. Mickiewicza 30, 30-059 Krakow, Poland.
- Institute of Fluid-Flow Machinery, Polish Academy of Sciences, Fiszera 14, 80-231 Gdansk, Poland.
ORCID-Profile: Jolanta Krupa, Jędrzej Blaut, Mateusz Kozioł, Łukasz Breńkacz
Förderung
- National Centre for Research and Development
Zitieren
APA
Krupa, J., Blaut, J., Warzecha, M., Kozioł, M., & Breńkacz, Ł. (2026). Tribological and Mechanical Performance of 3D-Printed Polymers for Water-Lubricated Sliding Bearings. Materials, 19(17), 3593. https://doi.org/10.3390/ma19173593
Vancouver
Krupa J, Blaut J, Warzecha M, Kozioł M, Breńkacz Ł. Tribological and Mechanical Performance of 3D-Printed Polymers for Water-Lubricated Sliding Bearings. Materials. 2026;19(17):3593. doi:10.3390/ma19173593
BibTeX
@article{Krupa2026,
author = {Krupa, Jolanta and Blaut, Jędrzej and Warzecha, Mariusz and Kozioł, Mateusz and Breńkacz, Łukasz},
title = {Tribological and Mechanical Performance of 3D-Printed Polymers for Water-Lubricated Sliding Bearings},
journal = {Materials},
year = {2026},
volume = {19},
number = {17},
pages = {3593},
doi = {10.3390/ma19173593}
}
EUVIMED