EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of Plant-Derived Modifiers on the Properties of Solvent Free Epoxy Coatings

Wojciech Żyłka iD, Barbara Pilch-Pitera iD, Piotr Potera iD, Renata Wojnarowska-Nowak iD, Małgorzata Pociask-Biały iD, Emilia Nowicka, Dominika Pitera, Beata Grabowska iD, Artur Bobrowski iD

Materials · 25.07.2026 · 19 (15) · 3183

DOI: 10.3390/ma19153183 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 25.07.2026. Verfasst von Wojciech Żyłka und 8 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Exact and Technical Sciences, Institute of Materials Engineering, University of Rzeszow, Pigonia 1, 35-310 Rzeszow, Poland. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 66 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Higher Education, he Ministry of Science and Higher Education, Republic of Poland.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, the effect of five natural plant modifiers, i.e., clove, ginger, dandelion, stinging nettle, and quinoa, on the surface and optical properties of epoxy coatings based on the Epidian® 5/IDA system was evaluated. The modifiers were introduced in a constant amount of 3.0 wt.% of the total sample mass. The samples were subjected to short-term UV-Vis (460 nm), UVB (320 nm), and UVC (254 nm) exposure, followed by measurements of Ra/Rz roughness, CIELAB colour, gloss, Raman spectra, reflectance, light transmittance, and moisture resistance under condensation conditions. The addition of modifiers increased the roughness compared with the reference coating, particularly in the case of the coating containing dandelion (Ra = 2.110 µm; Rz = 8.463 µm in the series without UV exposure), whereas UV exposure in many cases led to partial smoothing of the surface. The greatest colour change was observed after UVB irradiation for the coating containing quinoa (ΔE* = 7.10), with a simultaneous increase in the yellow component Δb*. The 60° gloss was strongly dependent on the type of additive; the lowest values were recorded for dandelion, and relatively higher values for clove and ginger. Raman spectra confirmed the presence of bands typical of plant components, while reflectance revealed the greatest sensitivity of changes in the UV range. The condensation test after 500 h showed that plant modifiers may deteriorate the barrier properties of the coatings, particularly in the case of nettle, dandelion, and clove. The results indicate that plant modifiers are promising additives for modifying the properties of epoxy coatings, but their application requires control of particle size, dispersion, and compatibility with the matrix.

Schlagwörter

Stichwörter der Autor:innen

CIELABRaman spectroscopyUV exposurecolor stabilityepoxy coatingsglosshumidity resistanceplant-based modifiersroughness

Autor:innen und Institutionen

  • Faculty of Exact and Technical Sciences, Institute of Materials Engineering, University of Rzeszow, Pigonia 1, 35-310 Rzeszow, Poland.
  • Department of Polymers and Biopolymers, Faculty of Chemistry, Rzeszów University of Technology, al. Powstańców Warszawy 12, 35-029 Rzeszów, Poland.
  • Center of Microelectronics and Nanotechnology, Institute of Materials Science and Engineering, University of Rzeszow, al. Rejtana 16c, 35-959 Rzeszów, Poland.
  • Private Medical Practice Dominika Pitera, ul. Trakt Węgierski 16, 38-450 Dukla, Poland.
  • Department of Foundry Process Engineering, Faculty of Foundry Engineering, AGH University of Krakow, al. A. Mickiewicza 30, 30-059 Kraków, Poland.

ORCID-Profile: Wojciech Żyłka, Barbara Pilch-Pitera, Piotr Potera, Renata Wojnarowska-Nowak, Małgorzata Pociask-Biały, Beata Grabowska, Artur Bobrowski

Förderung

  • Ministry of Science and Higher Education
  • he Ministry of Science and Higher Education, Republic of Poland

Zitieren

APA

Żyłka, W., Pilch-Pitera, B., Potera, P., Wojnarowska-Nowak, R., Pociask-Biały, M., Nowicka, E., Pitera, D., Grabowska, B., & Bobrowski, A. (2026). Influence of Plant-Derived Modifiers on the Properties of Solvent Free Epoxy Coatings. Materials, 19(15), 3183. https://doi.org/10.3390/ma19153183

Vancouver

Żyłka W, Pilch-Pitera B, Potera P, Wojnarowska-Nowak R, Pociask-Biały M, Nowicka E, et al. Influence of Plant-Derived Modifiers on the Properties of Solvent Free Epoxy Coatings. Materials. 2026;19(15):3183. doi:10.3390/ma19153183

BibTeX
@article{yka2026,
  author = {Żyłka, Wojciech and Pilch-Pitera, Barbara and Potera, Piotr and Wojnarowska-Nowak, Renata and Pociask-Biały, Małgorzata and Nowicka, Emilia and Pitera, Dominika and Grabowska, Beata and Bobrowski, Artur},
  title = {Influence of Plant-Derived Modifiers on the Properties of Solvent Free Epoxy Coatings},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {15},
  pages = {3183},
  doi = {10.3390/ma19153183}
}
Kostenlos starten →