EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Thermoelectric Generator Based on Kesterite (Cu2ZnSnS4) Synthesized via Sol–Gel Method

Afef Tarhouni, Marcelo Augusto Malagutti iD, Tanguy Bernard iD, Narges Ataollahi iD, Eleonora Isotta, Andrea Chiappini, Hassen Dahman, Lassaad El Mir iD, Paolo Scardi iD

Materials · 10.05.2026 · 19 (10) · 1971

DOI: 10.3390/ma19101971 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 10.05.2026. Verfasst von Afef Tarhouni und 8 weiteren Autor:innen. Beteiligte Einrichtung: LaphyMNE Laboratory, Faculty of Sciences of Gabes, University of Gabes, Gabes 6072, Tunisia. Die Arbeit nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministero dell'università e della ricerca, Ministry of Higher Education and Scientific Research, DICAM-EXC project.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The need for sustainable and cost-effective thermoelectric materials has brought attention to earth-abundant and mineral compounds, like Cu2ZnSnS4 (CZTS). In this work, CZTS nanoparticles (NPs) were synthesized via the sol–gel method using environmentally friendly solvents based on water and ethanol mixtures. The resulting CZTS NPs were then processed into inks through ball milling to produce a thin-film thermoelectric generator (TEG). Structural and microstructural properties were investigated via X-ray diffraction and Raman spectroscopy, confirming the kesterite CZTS phase upon sintering. The chalcogenide exhibited p-type semiconductor behaviour, with a Seebeck coefficient reaching ~69 µV/K at 385 K. Van-der-Pauw measurements of conductivity confirmed a non-degenerate semiconducting behaviour, achieving ~1.77 S/cm at 323 K. A two-leg CZTS thin-film TEG reaching a maximum power output of 32(3) nW at a ΔT ~160 K was used, measured with a home-made setup. The volume-specific power of the generator reached 4×10−4 μW cm−3 K−2. These results point to an effective use of sol–gel-based techniques to produce a functional thermoelectric generator, providing a costless and environmentally friendly approach to CZTS NPs.

Schlagwörter

Stichwörter der Autor:innen

CZTSSeebeck coefficientball millingdoctor bladepower factorsol–gelthermoelectric generator

Autor:innen und Institutionen

  • LaphyMNE Laboratory, Faculty of Sciences of Gabes, University of Gabes, Gabes 6072, Tunisia.
  • Department of Civil, Environmental and Mechanical Engineering, University of Trento, Via Mesiano 77, 38123 Trento, Italy.
  • CSMFO Laboratory, Fondazione Bruno Kessler (FBK) Photonics Unit, Institute of Photonics and Nanotechnologies (IFN-CNR), Via Alla Cascata 56/C, 39123 Trento, Italy.

ORCID-Profile: Marcelo Augusto Malagutti, Tanguy Bernard, Narges Ataollahi, Lassaad El Mir, Paolo Scardi

Förderung

  • Ministero dell'università e della ricerca
  • Ministry of Higher Education and Scientific Research
  • DICAM-EXC project
  • Tunisian Ministry of Higher Education and Scientific Research

Zitieren

APA

Tarhouni, A., Malagutti, M. A., Bernard, T., Ataollahi, N., Isotta, E., Chiappini, A., Dahman, H., El Mir, L., & Scardi, P. (2026). Thermoelectric Generator Based on Kesterite (Cu2ZnSnS4) Synthesized via Sol–Gel Method. Materials, 19(10), 1971. https://doi.org/10.3390/ma19101971

Vancouver

Tarhouni A, Malagutti MA, Bernard T, Ataollahi N, Isotta E, Chiappini A, et al. Thermoelectric Generator Based on Kesterite (Cu2ZnSnS4) Synthesized via Sol–Gel Method. Materials. 2026;19(10):1971. doi:10.3390/ma19101971

BibTeX
@article{Tarhouni2026,
  author = {Tarhouni, Afef and Malagutti, Marcelo Augusto and Bernard, Tanguy and Ataollahi, Narges and Isotta, Eleonora and Chiappini, Andrea and Dahman, Hassen and El Mir, Lassaad and Scardi, Paolo},
  title = {Thermoelectric Generator Based on Kesterite (Cu2ZnSnS4) Synthesized via Sol–Gel Method},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {10},
  pages = {1971},
  doi = {10.3390/ma19101971}
}
Kostenlos starten →