EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Potential Application of Epoxy Powder Coating Waste in Concrete: Strength Properties and Durability of Concrete

Janusz Konkol iD, Bernardeta Dębska iD, Andriy Huts iD, Barbara Pilch-Pitera iD, Guilherme Jorge Brigolini Silva iD, Cristopher Antonio Martins De Moura iD, Wioleta Iskra-Kozak iD, Jerzy Szyszka iD

Materials · 25.04.2026 · 19 (9) · 1756

DOI: 10.3390/ma19091756 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 25.04.2026. Verfasst von Janusz Konkol und 7 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Civil and Environmental Engineering and Architecture, Rzeszow University of Technology, 35-029 Rzeszow, Poland. Die Arbeit nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Minister of Science and Higher Education.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents the results of tests on concrete modified with waste powder from the production of epoxy powder coating, planned using design of experiment’s (DOE) experimental design methods. The scope of the investigation included detailed identification of the waste itself (TG/DTA, FTIR, SEM + EDS, laser diffraction), as well as evaluation of selected properties of concretes containing this waste, including compressive strength, density, and durability parameters such as frost resistance and chemical resistance. The scope of the experiment was defined by varying modifier content in the range of 4 to 11% of the cement mass and a water-cement ratio between 0.44 and 0.56. The concrete mixes obtained were characterized by good workability, fluidity, and consistency stability over time, despite the use of the modifier as an additional component in the concrete mix. No adverse effect of the waste used on the durability of the concrete was observed. Concretes modified with waste from the production of epoxy powder coating achieved a frost resistance class of F150 and showed good resistance to chemically aggressive environments (sulfates and chlorides). No products indicating adverse reactions between waste powder and reagents were found. The use of the DOE approach made it possible to determine, in the form of functional relationships, the influence of the modifier content depending on the water-cement ratio (w/c) of the concrete on its compressive strength and density. In general, a decrease in the compressive strength of concrete containing a waste powder modifier was observed, ranging from approximately 11% to 26% compared to unmodified concrete. However, the trend of decreasing compressive strength was reduced as the water-cement ratio of concrete decreased. At a water-cement ratio (w/c) of 0.443, no further decrease in compressive strength was observed. Concrete with 11% waste powder and a w/c ratio of 0.443 achieved 4.7% higher compressive strength than unmodified concrete with the same water-cement ratio. A beneficial interaction was found between a carboxylate-based plasticizer and the waste powder from the production of epoxy powder coatings. The proposed method of using waste as a concrete component is promising and may contribute to reducing the problem of waste management, as well as greenhouse gas emissions.

Schlagwörter

Stichwörter der Autor:innen

circular economycompressive strengthdurability of concreteepoxy powder coating wastesustainable concrete

Autor:innen und Institutionen

  • Faculty of Civil and Environmental Engineering and Architecture, Rzeszow University of Technology, 35-029 Rzeszow, Poland.
  • Faculty of Chemistry, Rzeszow University of Technology, 35-029 Rzeszow, Poland.
  • Departamento de Engenharia Civil, Universidade Federal de Ouro Preto, Campus Morro do Cruzeiro, Ouro Preto 35400-000, MG, Brazil.
  • Instituto de Ciências Exatas e da Terra, Universidade Federal de Mato Grosso, Campus Universitário do Araguaia, Barra do Garças 78060-900, MG, Brazil.

ORCID-Profile: Janusz Konkol, Bernardeta Dębska, Andriy Huts, Barbara Pilch-Pitera, Guilherme Jorge Brigolini Silva, Cristopher Antonio Martins De Moura, Wioleta Iskra-Kozak, Jerzy Szyszka

Förderung

  • Minister of Science and Higher Education

Zitieren

APA

Konkol, J., Dębska, B., Huts, A., Pilch-Pitera, B., Silva, G. J. B., De Moura, C. A. M., Iskra-Kozak, W., & Szyszka, J. (2026). Potential Application of Epoxy Powder Coating Waste in Concrete: Strength Properties and Durability of Concrete. Materials, 19(9), 1756. https://doi.org/10.3390/ma19091756

Vancouver

Konkol J, Dębska B, Huts A, Pilch-Pitera B, Silva GJB, De Moura CAM, et al. Potential Application of Epoxy Powder Coating Waste in Concrete: Strength Properties and Durability of Concrete. Materials. 2026;19(9):1756. doi:10.3390/ma19091756

BibTeX
@article{Konkol2026,
  author = {Konkol, Janusz and Dębska, Bernardeta and Huts, Andriy and Pilch-Pitera, Barbara and Silva, Guilherme Jorge Brigolini and De Moura, Cristopher Antonio Martins and Iskra-Kozak, Wioleta and Szyszka, Jerzy},
  title = {Potential Application of Epoxy Powder Coating Waste in Concrete: Strength Properties and Durability of Concrete},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {9},
  pages = {1756},
  doi = {10.3390/ma19091756}
}
Kostenlos starten →