Hot-Pressed Multicomponent Recycled Textile Polymer Blends Reinforced with Ground GFRP from Wind Turbine Blades: Microstructure–Property Relationships
Materials · 26.03.2026 · 19 (7) · 1306
DOI: 10.3390/ma19071306 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 26.03.2026. Verfasst von Maciej Wędrychowicz und 7 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Materials and Biomedical Engineering, Faculty of Engineering and Technical Sciences, University of Zielona Gora, Prof. Z. Szafrana Stree…. Die Arbeit nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Polish National Center for Research and Development,, Polish National Center for Research and Development.
Abstract (Originalsprache)
This study investigates hot-pressed composite plates manufactured from pellets obtained by mechanical recycling of post-consumer textile waste and reinforced with ground glass-fiber-reinforced polymer (GFRP) originating from wind turbine blades. Composite plates with dimensions of 200 × 330 × 8 mm were produced by hot pressing at 240 °C under 2 MPa with a heating and pressing time of 40 min. The recycled textile-derived polymer blend served as the matrix, while ground GFRP was introduced at 0, 10, 20, and 30 wt.%. Mechanical performance was evaluated using flexural and Charpy impact tests. The composites exhibited flexural strengths in the range of 9–13 MPa and impact strengths of 7.3–8.9 kJ m−2. The results did not reveal a monotonic increase in flexural strength with increasing reinforcement content. The highest average flexural strength was observed for the unreinforced matrix, while the addition of ground GFRP resulted in comparable or slightly lower strength values accompanied by increased scatter at higher reinforcement levels. The observed behaviour may be associated with heterogeneous dispersion of ground GFRP fragments, reduced effective reinforcement length due to mechanical grinding, interfacial constraints, and defect formation within the press-consolidated structure. The findings provide insight into the structure–property relationships of recycled composite systems based on heterogeneous textile-derived polymer blends.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Institute of Materials and Biomedical Engineering, Faculty of Engineering and Technical Sciences, University of Zielona Gora, Prof. Z. Szafrana Street, 65-516 Zielona Gora, Poland.
- Institute of Mechanical Engineering, Faculty of Engineering and Technical Sciences, University of Zielona Gora, Prof. Z. Szafrana Street, 65-516 Zielona Gora, Poland.
- Faculty of Non-Ferrous Metals, AGH University of Science and Technology, A. Mickiewicza Av. 30, 30-059 Cracow, Poland.
ORCID-Profile: Maciej Wędrychowicz, Jagoda Kurowiak, Tomasz Skrzekut, Piotr Noga
Förderung
- Polish National Center for Research and Development,
- Polish National Center for Research and Development
Zitieren
APA
Wędrychowicz, M., Papacz, W., Walkowiak, J., Kurowiak, J., Siwczyk, B., Skrzekut, T., Noga, P., & Skarupska, D. (2026). Hot-Pressed Multicomponent Recycled Textile Polymer Blends Reinforced with Ground GFRP from Wind Turbine Blades: Microstructure–Property Relationships. Materials, 19(7), 1306. https://doi.org/10.3390/ma19071306
Vancouver
Wędrychowicz M, Papacz W, Walkowiak J, Kurowiak J, Siwczyk B, Skrzekut T, et al. Hot-Pressed Multicomponent Recycled Textile Polymer Blends Reinforced with Ground GFRP from Wind Turbine Blades: Microstructure–Property Relationships. Materials. 2026;19(7):1306. doi:10.3390/ma19071306
BibTeX
@article{Wdrychowicz2026,
author = {Wędrychowicz, Maciej and Papacz, Władysław and Walkowiak, Janusz and Kurowiak, Jagoda and Siwczyk, Bartosz and Skrzekut, Tomasz and Noga, Piotr and Skarupska, Dominika},
title = {Hot-Pressed Multicomponent Recycled Textile Polymer Blends Reinforced with Ground GFRP from Wind Turbine Blades: Microstructure–Property Relationships},
journal = {Materials},
year = {2026},
volume = {19},
number = {7},
pages = {1306},
doi = {10.3390/ma19071306}
}
EUVIMED