EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Mechanical and Environmental Performance of Concrete Incorporating Post-Consumer Plastics and E-Waste

Madiha Ammari, Halil Sezen, Jose Castro

Materials · 23.03.2026 · 19 (6) · 1259

DOI: 10.3390/ma19061259 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 23.03.2026. Verfasst von Madiha Ammari und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Civil and Environmental Engineering, Morgan State University, Baltimore, MD 21251, USA. Die Arbeit nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A significant portion of plastic products is not accepted by curbside recycling companies and goes to landfills or incineration, causing an adverse impact on the environment. This study investigated the effects of utilizing post-consumer plastic and e-waste in concrete. A plastic product made of thermoplastic polypropylene (PP) was ground into fine particles and used for 10% volumetric replacement of sand, while bare printed circuit boards (PCBs) were pulverized into powder and used for 10% cement replacement by mass. This study introduces a unique utilization of grounded powder PCBs by partially replacing cement in concrete. Furthermore, reinforced concrete beams with the replacements were constructed and tested under flexure for structural behavior evaluation. The results of this study show an average of 11% reduction in both the compressive strength of concrete and the maximum load capacity of the beams incorporating plastic products. A life cycle assessment study was conducted using a functional unit of 1.0 cubic yard concrete production. The system boundary for the environmental assessment of the concrete in this study includes only the production phase, which is from the cradle to the end gate of the ready-mix concrete plant. The environmental impact estimation of a 10% reduction in constituents of concrete showed a 10% reduction in most LCA measures where cement was replaced compared to a 1% effect for the fine aggregate replacement.

Schlagwörter

Stichwörter der Autor:innen

aggregatecementcompressive strengthconcreteflexural behaviorlife cycle assessmentplasticpolypropyleneprinted circuit boardswaste valorization

Autor:innen und Institutionen

  • Department of Civil and Environmental Engineering, Morgan State University, Baltimore, MD 21251, USA.
  • Department of Civil, Environmental and Geodetic Engineering, The Ohio State University, Columbus, OH 43210, USA.
  • Department of Integrated Systems Engineering, The Ohio State University, Columbus, OH 43210, USA.

Zitieren

APA

Ammari, M., Sezen, H., & Castro, J. (2026). Mechanical and Environmental Performance of Concrete Incorporating Post-Consumer Plastics and E-Waste. Materials, 19(6), 1259. https://doi.org/10.3390/ma19061259

Vancouver

Ammari M, Sezen H, Castro J. Mechanical and Environmental Performance of Concrete Incorporating Post-Consumer Plastics and E-Waste. Materials. 2026;19(6):1259. doi:10.3390/ma19061259

BibTeX
@article{Ammari2026,
  author = {Ammari, Madiha and Sezen, Halil and Castro, Jose},
  title = {Mechanical and Environmental Performance of Concrete Incorporating Post-Consumer Plastics and E-Waste},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {6},
  pages = {1259},
  doi = {10.3390/ma19061259}
}
Kostenlos starten →