EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Mechanical Properties and Freeze–Thaw Cycling Degradation of Loess Improved with an Ionic Curing Agent and Cement Composite

Xingwei Wang, Jiandong Li, Xu Wang, Baiwei Li, Yanjie Zhang, Zhen Zuo iD

Materials · 21.03.2026 · 19 (6) · 1242

DOI: 10.3390/ma19061242 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 21.03.2026. Verfasst von Xingwei Wang und 5 weiteren Autor:innen. Beteiligte Einrichtung: School of Civil Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China Project, Special Project for Scientific and Technological Special Commissioners of Gansu Province Science and Technology Program, Gansu Province Industrial Support Program Project.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To address the engineering problems of high cement content, high brittleness, and weak frost resistance of cement-improved loess in the seasonal frozen soil area of Northwest China, F1 ion curing agent (F1) and cement composite improved loess (FCIL) were used in this paper. Through unconfined compressive (UC) strength tests, consolidated undrained (CU) triaxial shear tests, and microscopic pore characteristics analysis, the mechanical properties, freeze–thaw cycle deterioration law, and microscopic pore structure of FCIL were studied. The effects of cement content (Cc), F1 dosage (CF), number of freeze–thaw cycles (NF-T), and confining pressure (σ3) on the strength, deformation behavior, and pore characteristics of FCIL were analyzed. The synergistic improvement mechanism of FCIL, as well as the freeze–thaw damage mechanism, was elucidated. The results show that Cc is the primary factor controlling the strength of improved loess. The incorporation of F1 can further increase UCS and markedly enhance the failure strain (εf), thereby achieving simultaneous improvements in strength and ductility. An appropriate mix proportion was identified as CF = 0.2 L/m3 and Cc = 6%. After 7 d curing, FCIL exhibited a UCS of 1.35 MPa, a cohesion (c) of 205 kPa, an internal friction angle (φ) of 36.2°, and εf 1.8 times that of loess improved with Cc = 6% cement alone. CU triaxial shear tests indicate that, under all tested conditions, the stress–strain responses of FCIL exhibit σ3-sensitive strain-softening behavior. As Cc and σ3 increase, triaxial peak strength (qmax) and secant modulus (E50) increase significantly. Compared with natural loess (NL), FCIL shows a markedly lower porosity (n), a substantial increase in the proportion of micropores, and reductions in medium and small pores. After multiple freeze–thaw cycles, the evolution of the pore structure is effectively restrained. This indicates that the combined use of F1 and cement promotes the formation of a dense layered stacking structure, significantly improves the microscopic pore-size distribution, and enhances the mechanical performance of loess under freeze–thaw environments.

Schlagwörter

Stichwörter der Autor:innen

NMR pore size distributioncement stabilizationfreeze-thaw durabilityimproved loessionic curing agent

Autor:innen und Institutionen

  • School of Civil Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China.
  • National and Local Joint Engineering Laboratory for Disaster Prevention and Control in Road and Bridge Engineering, Lanzhou 730070, China.

ORCID-Profile: Zhen Zuo

Förderung

  • National Natural Science Foundation of China Project
  • Special Project for Scientific and Technological Special Commissioners of Gansu Province Science and Technology Program
  • Gansu Province Industrial Support Program Project
  • The Youth Doctoral Support Project of the Education Department of Gansu Province
  • Patent Transformation Guidance Fund Project of Lanzhou Jiaotong University
  • Youth Doctoral Support Project of the Education Department of Gansu Province
  • Gansu Provincial Department of Education: Outstanding Graduate Student “Innovation Star” Project

Zitieren

APA

Wang, X., Li, J., Wang, X., Li, B., Zhang, Y., & Zuo, Z. (2026). Mechanical Properties and Freeze–Thaw Cycling Degradation of Loess Improved with an Ionic Curing Agent and Cement Composite. Materials, 19(6), 1242. https://doi.org/10.3390/ma19061242

Vancouver

Wang X, Li J, Wang X, Li B, Zhang Y, Zuo Z. Mechanical Properties and Freeze–Thaw Cycling Degradation of Loess Improved with an Ionic Curing Agent and Cement Composite. Materials. 2026;19(6):1242. doi:10.3390/ma19061242

BibTeX
@article{Wang2026,
  author = {Wang, Xingwei and Li, Jiandong and Wang, Xu and Li, Baiwei and Zhang, Yanjie and Zuo, Zhen},
  title = {Mechanical Properties and Freeze–Thaw Cycling Degradation of Loess Improved with an Ionic Curing Agent and Cement Composite},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {6},
  pages = {1242},
  doi = {10.3390/ma19061242}
}
Kostenlos starten →