EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Assessment of the Mechanical Properties and Durability of Cement Mortars Modified with Polyurethane Foam Waste

Gabriela Rutkowska iD, Barbara Francke iD, Filip Chyliński iD, Mariusz Żółtowski iD, Hanna Michalak iD, Agnieszka Starzyk iD, Michał Musiał iD, Oskar Sierakowski

Materials · 26.01.2026 · 19 (3) · 491

DOI: 10.3390/ma19030491 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 26.01.2026. Verfasst von Gabriela Rutkowska und 7 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Civil Engineering, Warsaw University of Life Sciences, Nowoursynowska 166, 02-787 Warsaw, Poland. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Scientific Council of the Discipline of "Architecture and Urban Planning", Warsaw University of Technology, Scientific Council of the Discipline of “Architecture and Urban Planning”, Warsaw University of Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the era of growing demand for sustainable solutions in construction, increasing attention is being paid to the potential use of waste materials as components of building composites. This article presents the results of a study on the impact of ground polyurethane foam waste on the mechanical properties and durability of cement mortars. The waste, derived from industrial production processes, was used as a partial replacement for fine aggregates in various proportions. The analysis included bulk density, compressive and flexural strengths, water absorption, and resistance to freeze–thaw cycles. The results indicate that adding waste reduces the density of the mortar, which can be advantageous in applications requiring lightweight materials. The most favourable balance of strength retention, density reduction, and frost resistance was observed with a 1% addition, as the mortar maintained good mechanical performance and freeze–thaw durability while achieving reduced weight. Higher waste content (2–3%) led to significant deterioration of the mechanical properties due to increased porosity. All samples exhibited increased strength after 25 freeze–thaw cycles, possibly due to continued hydration under moist low-temperature conditions. The analysis of the microstructure of cement coatings with the addition of polyurethane foam enabled the explanation of the causes of the observed changes in physico-mechanical properties resulting from ageing factors. This study suggests that small amounts of waste can be effectively used to produce lightweight and environmentally friendly construction materials, supporting circular economy practices.

Schlagwörter

Stichwörter der Autor:innen

durabilitymechanical performancemicrostructure analysispolyurethane foam wastewaste utilisation cement mortar

Autor:innen und Institutionen

  • Institute of Civil Engineering, Warsaw University of Life Sciences, Nowoursynowska 166, 02-787 Warsaw, Poland.
  • Building Research Institute, Filtrowa 1, 00-611 Warsaw, Poland.
  • Faculty of Architecture, Warsaw University of Technology, Plac Politechniki 1, 00-611 Warsaw, Poland.
  • KERAKOLL POLSKA Sp. z o.o., ul. Katowicka 128, 95-030 Rzgów, Poland.

ORCID-Profile: Gabriela Rutkowska, Barbara Francke, Filip Chyliński, Mariusz Żółtowski, Hanna Michalak, Agnieszka Starzyk, Michał Musiał

Förderung

  • Scientific Council of the Discipline of "Architecture and Urban Planning", Warsaw University of Technology
  • Scientific Council of the Discipline of “Architecture and Urban Planning”, Warsaw University of Technology

Zitieren

APA

Rutkowska, G., Francke, B., Chyliński, F., Żółtowski, M., Michalak, H., Starzyk, A., Musiał, M., & Sierakowski, O. (2026). Assessment of the Mechanical Properties and Durability of Cement Mortars Modified with Polyurethane Foam Waste. Materials, 19(3), 491. https://doi.org/10.3390/ma19030491

Vancouver

Rutkowska G, Francke B, Chyliński F, Żółtowski M, Michalak H, Starzyk A, et al. Assessment of the Mechanical Properties and Durability of Cement Mortars Modified with Polyurethane Foam Waste. Materials. 2026;19(3):491. doi:10.3390/ma19030491

BibTeX
@article{Rutkowska2026,
  author = {Rutkowska, Gabriela and Francke, Barbara and Chyliński, Filip and Żółtowski, Mariusz and Michalak, Hanna and Starzyk, Agnieszka and Musiał, Michał and Sierakowski, Oskar},
  title = {Assessment of the Mechanical Properties and Durability of Cement Mortars Modified with Polyurethane Foam Waste},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {3},
  pages = {491},
  doi = {10.3390/ma19030491}
}
Kostenlos starten →