EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Influence of Two-Region Morphology and Grain Shape on the Transport Critical Current Density in the Range from 15 K to 30 K in SiC-Doped MgB2 Wires Fabricated by the Powder-in-Tube Method

Daniel Gajda, Michał Babij iD, Andrzej Zaleski iD, Dogan Avci iD, Hakan Yetis, Ibrahim Belenli iD, Fırat Karaboga, Damian Szymanski, Tomasz Czujko iD

Materials · 24.08.2025 · 18 (17) · 3960

DOI: 10.3390/ma18173960 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 24.08.2025. Verfasst von Daniel Gajda und 8 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Low Temperature and Structure Research, Polish Academy of Sciences (PAS), 50-422 Wroclaw, Poland. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: The Department of Materials Technology, Military University of Technology, Department of Materials Technology, Military University of Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The paper presents the results of the influence of SiC dopant, annealing temperature, and annealing time on the morphology of MgB2 material in superconducting wires. The results of measurements of critical temperature (Tc), irreversible magnetic field (Birr), resistance in the normal state (Rn), and transport critical current density (Jct) at the temperature range from 15 K to 30 K are presented. The MgB2 material is characterized by the presence of two specific regions. The first region with high density, excess Mg, and rectangular MgB2 grains is located outside the voids surrounding them. The second region occurs inside the ceramic core, away from voids, and its chemical composition corresponds to a stoichiometric Mg to B ratio (1:2), and it is characterized by the presence of spherical grains and lower material density. A higher amount of SiC admixtures (6 at.%) causes an increase in the first region surface area. This kind of structure observation in MgB2 superconducting wires has never been reported previously. The transport measurements showed that higher SiC dopant leads to lower Jct at higher temperatures and high magnetic fields. The studies showed that the point-dominant mechanism and the first region allow for obtaining high Jct at 30 K.

Schlagwörter

Stichwörter der Autor:innen

MgB2critical current densitysuperconductive wires

Autor:innen und Institutionen

  • Institute of Low Temperature and Structure Research, Polish Academy of Sciences (PAS), 50-422 Wroclaw, Poland.
  • Quatum Metrology Laboratory, National Metrology Institute TÜB ITAK, 41470 Kocaeli, Türkiye.
  • Department of Physics, Bolu Abant Izzet Baysal University, 14280 Bolu, Türkiye.
  • Mehmet Tanrikulu Vocational School of Health Services, Bolu Abant Izzet Baysal University, 14030 Bolu, Türkiye.
  • Institute of Materials Science and Engineering, Military University of Technology, 00-908 Warsaw, Poland.

ORCID-Profile: Michał Babij, Andrzej Zaleski, Dogan Avci, Ibrahim Belenli, Tomasz Czujko

Förderung

  • The Department of Materials Technology, Military University of Technology
  • Department of Materials Technology, Military University of Technology

Zitieren

APA

Gajda, D., Babij, M., Zaleski, A., Avci, D., Yetis, H., Belenli, I., Karaboga, F., Szymanski, D., & Czujko, T. (2025). The Influence of Two-Region Morphology and Grain Shape on the Transport Critical Current Density in the Range from 15 K to 30 K in SiC-Doped MgB2 Wires Fabricated by the Powder-in-Tube Method. Materials, 18(17), 3960. https://doi.org/10.3390/ma18173960

Vancouver

Gajda D, Babij M, Zaleski A, Avci D, Yetis H, Belenli I, et al. The Influence of Two-Region Morphology and Grain Shape on the Transport Critical Current Density in the Range from 15 K to 30 K in SiC-Doped MgB2 Wires Fabricated by the Powder-in-Tube Method. Materials. 2025;18(17):3960. doi:10.3390/ma18173960

BibTeX
@article{Gajda2025,
  author = {Gajda, Daniel and Babij, Michał and Zaleski, Andrzej and Avci, Dogan and Yetis, Hakan and Belenli, Ibrahim and Karaboga, Fırat and Szymanski, Damian and Czujko, Tomasz},
  title = {The Influence of Two-Region Morphology and Grain Shape on the Transport Critical Current Density in the Range from 15 K to 30 K in SiC-Doped MgB2 Wires Fabricated by the Powder-in-Tube Method},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {17},
  pages = {3960},
  doi = {10.3390/ma18173960}
}
Kostenlos starten →