Tribotechnical and Physical Characteristics of a Friction Composite Made of a Polymer Matrix Reinforced with a Complex of Fiber-Dispersed Particles
Materials · 16.08.2025 · 18 (16) · 3847
DOI: 10.3390/ma18163847 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 16.08.2025. Verfasst von Ievgen Byba und 5 weiteren Autor:innen. Beteiligte Einrichtung: E.O. Paton Education and Research Institute of Materials Science and Welding, National Technical University of Ukraine 'Igor Sikorsky Kyiv Polytechni…. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Kyivska Polytechnika (Chongqing, China) (Co, Ltd.).
Abstract (Originalsprache)
A friction composite material which contains cellulose fiber, carbon fiber, wollastonite, graphite, and resin for use in oil-cooled friction units, hydromechanical boxes, and couplings was developed. The fabrication technique includes the formation of a paper layer based on the mixture of stated fibers via a wet-laid process, impregnation of the layer with phenolic resin, and hot pressing onto a steel carrier. The infrared spectra of the polymeric base (phenolic resin) were studied by solvent extraction. The structural-phase analysis of the obtained material was carried out by the SEM method, and the particle size distribution parameters of the composite components were estimated based on the images of the sample surface. The surface roughness parameters of the samples are as follows: Ra = 5.7 μm Rz = 31.4 μm. The tribotechnical characteristics of the material were tested in an oil medium at a load of 5.0 MPa and a rotation mode of 2000 rpm for 180 min in a pair with a steel 45 counterbody. The coefficient of friction of the developed material was 0.11–0.12; the degree of wear was 6.17 × 10−6 μm/mm. The degree of compression deformation of the composite is 0.36%, and the compressive strength is 7.8 MPa. The calculated kinetic energy absorbed and power level are 205 J/cm2 and 110 W/cm2, respectively. The main tribotechnical characteristics of the developed friction material correspond to industrial analogues.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- E.O. Paton Education and Research Institute of Materials Science and Welding, National Technical University of Ukraine 'Igor Sikorsky Kyiv Polytechnic Institute', 37, Beresteiskyi Ave., UA-03056 Kyiv, Ukraine.
- Institute of Applied Control Systems of the N.A.S of Ukraine, 40, Glushkov Akademika Avenue, UA-03187 Kyiv, Ukraine.
- Education and Research Institute of Mechanical Engineering, National Technical University of Ukraine 'Igor Sikorsky Kyiv Polytechnic Institute', 37, Beresteiskyi Ave., UA-03056 Kyiv, Ukraine.
- Vice-Rector for International Relations, National Technical University of Ukraine 'Igor Sikorsky Kyiv Polytechnic Institute', 37, Beresteiskyi Ave., UA-03056 Kyiv, Ukraine.
- Faculty of Chemical Technology, National Technical University of Ukraine 'Igor Sikorsky Kyiv Polytechnic Institute', 37, Beresteiskyi Ave., UA-03056 Kyiv, Ukraine.
- Technical Center, N.A.S. of Ukraine, 13, Pokrovs'ka Str., UA-04070 Kyiv, Ukraine.
ORCID-Profile: Ievgen Byba, Anatolii Minitskyi, Yuriy Sydorenko, Oleksiy Myronyuk, Maksym Barabash
Förderung
- Kyivska Polytechnika (Chongqing, China) (Co, Ltd.)
Zitieren
APA
Byba, I., Minitskyi, A., Sydorenko, Y., Shysholin, A., Myronyuk, O., & Barabash, M. (2025). Tribotechnical and Physical Characteristics of a Friction Composite Made of a Polymer Matrix Reinforced with a Complex of Fiber-Dispersed Particles. Materials, 18(16), 3847. https://doi.org/10.3390/ma18163847
Vancouver
Byba I, Minitskyi A, Sydorenko Y, Shysholin A, Myronyuk O, Barabash M. Tribotechnical and Physical Characteristics of a Friction Composite Made of a Polymer Matrix Reinforced with a Complex of Fiber-Dispersed Particles. Materials. 2025;18(16):3847. doi:10.3390/ma18163847
BibTeX
@article{Byba2025,
author = {Byba, Ievgen and Minitskyi, Anatolii and Sydorenko, Yuriy and Shysholin, Andrii and Myronyuk, Oleksiy and Barabash, Maksym},
title = {Tribotechnical and Physical Characteristics of a Friction Composite Made of a Polymer Matrix Reinforced with a Complex of Fiber-Dispersed Particles},
journal = {Materials},
year = {2025},
volume = {18},
number = {16},
pages = {3847},
doi = {10.3390/ma18163847}
}
EUVIMED