Performance of 3D Network-Structured LiFePO4@Li3V2(PO4)3/Carbon Nanofibers via Coaxial Electrospinning as Self-Supporting Cathode for Lithium-Ion Batteries
Materials · 26.04.2025 · 18 (9) · 1969
DOI: 10.3390/ma18091969 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 26.04.2025. Verfasst von Ruixia Chu und 6 weiteren Autor:innen. Beteiligte Einrichtung: Automotive Engineering College, Shandong Jiaotong University, Jinan 250357, China. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Provincial Science and Technology Innovation Platform Subsidy Project, the Key R&D Program of Shandong Province, the Shandong Provincial Natural Science Foundation.
Abstract (Originalsprache)
Lithium-ion batteries (LIBs) with high power, high capacity, and support for fast charging are increasingly favored by consumers. As a commercial electrode material for power batteries, LiFePO4 was limited from further wide application due to its low conductivity and lithium-ion diffusion rate. The development of advanced architectures integrating rational conductive networks with optimized ion transport pathways represents a critical frontier in optimizing the performance of cathode materials. In this paper, a novel self-supporting cathode material (designated as LFP@LVP-CES) was synthesized through an integrated coaxial electrospinning and controlled pyrolysis strategy. This methodology directly converts LiFePO4, Li3V2(PO4)3, and polyacrylonitrile (PAN)) into flexible, binder-free cathodes with a hierarchical structural organization. The 3D carbon nanofiber (CNF) matrix synergistically integrates LiFePO4 (Li/Fe/POx) and Li3V2(PO4)3 (Li/V/POx) nanoparticles, where CNFs act as a conductive scaffold to enhance electron transport, while the POx polyanionic frameworks stabilize Li+ diffusion pathways. Morphological characterizations (SEM and TEM) revealed a 3D cross-connected carbon nanofiber matrix (diameter: 250 ± 50 nm) uniformly embedded with active material particles. Electrochemical evaluations demonstrated that the LFP@LVP-CES cathode delivers an initial specific capacity of 165 mAh·g−1 at 0.1 C, maintaining 80 mAh·g−1 at 5 C. Notably, the material exhibited exceptional rate capability and cycling stability, demonstrating a 96% capacity recovery after high-rate cycling upon returning to 0.1 C, along with 97% capacity retention over 200 cycles at 1 C. Detailed kinetic analysis through EIS revealed significantly reduced Rct and increased Li+ diffusion. This superior electrochemical performance can be attributed to the synergistic effects between the 3D conductive network architecture and dual active materials. Compared with traditional coating processes and high-temperature calcination, the preparation of controllable electrospinning and low-temperature pyrolysis to some extent avoid the introduction of harmful substances and reduce raw material consumption and carbon emissions. This original integration strategy establishes a paradigm for designing freestanding electrode architectures through 3D structural design combined with a bimodal active material, providing critical insights for next-generation energy storage systems.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Automotive Engineering College, Shandong Jiaotong University, Jinan 250357, China.
- Intelligent Testing and High-End Equipment of Automotive Power Systems, Shandong Province Engineering Research Center, Jinan 250357, China.
- Jinan Engineering Research Center of Automotive Equipment and Technology, Jinan 250357, China.
ORCID-Profile: Wanyou Huang
Förderung
- the Provincial Science and Technology Innovation Platform Subsidy Project
- the Key R&D Program of Shandong Province
- the Shandong Provincial Natural Science Foundation
- The Key R&D Program of Shandong Province, China
Zitieren
APA
Chu, R., Zhang, H., Huang, W., Qiu, F., Wang, Y., Li, Z., & Jin, X. (2025). Performance of 3D Network-Structured LiFePO4@Li3V2(PO4)3/Carbon Nanofibers via Coaxial Electrospinning as Self-Supporting Cathode for Lithium-Ion Batteries. Materials, 18(9), 1969. https://doi.org/10.3390/ma18091969
Vancouver
Chu R, Zhang H, Huang W, Qiu F, Wang Y, Li Z, et al. Performance of 3D Network-Structured LiFePO4@Li3V2(PO4)3/Carbon Nanofibers via Coaxial Electrospinning as Self-Supporting Cathode for Lithium-Ion Batteries. Materials. 2025;18(9):1969. doi:10.3390/ma18091969
BibTeX
@article{Chu2025,
author = {Chu, Ruixia and Zhang, Hongtao and Huang, Wanyou and Qiu, Fangyuan and Wang, Yan and Li, Zhenyu and Jin, Xiaoyue},
title = {Performance of 3D Network-Structured LiFePO4@Li3V2(PO4)3/Carbon Nanofibers via Coaxial Electrospinning as Self-Supporting Cathode for Lithium-Ion Batteries},
journal = {Materials},
year = {2025},
volume = {18},
number = {9},
pages = {1969},
doi = {10.3390/ma18091969}
}
EUVIMED